Showing 1–9 of 9 results for author: Whitten, J L

SHARAD Illuminates Deeper Martian Subsurface Structures with a Boost from Very Large Rolls of the MRO Spacecraft

Authors: Nathaniel E. Putzig, Gareth A. Morgan, Matthew R. Perry, Bruce A. Campbell, Jennifer L. Whitten, Fabrizio Bernardini, Alessandro DiCarlofelice, Piero Tognolatti, Pierfrancesco Lombardo

Abstract: Throughout its mission, the Mars Reconnaissance Orbiter (MRO) has often rolled about its along-track axis by up to 28° to partially compensate for the suboptimal location of the Shallow Radar (SHARAD) antenna along an edge of the spacecraft that is opposite the imaging payload deck, thereby enhancing the signal-to-noise ratio (S/N) of echoes returned from the surface. After recent modeling work pr… ▽ More Throughout its mission, the Mars Reconnaissance Orbiter (MRO) has often rolled about its along-track axis by up to 28° to partially compensate for the suboptimal location of the Shallow Radar (SHARAD) antenna along an edge of the spacecraft that is opposite the imaging payload deck, thereby enhancing the signal-to-noise ratio (S/N) of echoes returned from the surface. After recent modeling work predicted that a much larger roll would improve the S/N by ~10 dB relative to nadir-pointed observing, MRO began a limited series of 120° roll maneuvers to test the effects on radar sounding. Three such SHARAD very-large-roll (VLR) observations have been acquired since May 2023, and they show dramatic improvements in signal clarity and depth of penetration, with S/N increasing by 9, 11, and 14 dB over that of nearly coincident observations at 0° roll angle. In low dielectric terrains, the first and second VLR observations enabled basal detections at depths previously unachievable, reaching depths of 800 m in Medusae Fossae materials and 1500 m through the ice of Ultimi Scopuli, respectively. The second VLR observation also obtained enhanced reflections throughout the ice stack. In the higher dielectric terrain of Amazonis Planitia, the third VLR observation improved continuity of a dipping subsurface interface, but it revealed neither an extension of the interface to greater depths nor any deeper interfaces. The MRO mission intends to obtain more SHARAD VLR observations of polar terrains and of midlatitude glacial and ground ices, sediments, and volcanics. △ Less

Submitted 28 May, 2025; v1 submitted 27 May, 2025; originally announced May 2025.

Comments: Accepted manuscript with 21 pages, 7 figures

Correction of Residual Errors in Configuration Interaction Electronic Structure Calculations

Authors: Jerry L. Whitten

Abstract: Methods for correcting residual energy errors of configuration interaction (CI) calculations of molecules and other electronic systems are discussed based on the assumption that the energy defect can be mapped onto atomic regions. The methods do not consider the detailed nature of excitations, but instead define a defect energy per electron that that is unique to a specific atom. Defect energy con… ▽ More Methods for correcting residual energy errors of configuration interaction (CI) calculations of molecules and other electronic systems are discussed based on the assumption that the energy defect can be mapped onto atomic regions. The methods do not consider the detailed nature of excitations, but instead define a defect energy per electron that that is unique to a specific atom. Defect energy contributions are determined from calculations on diatomic and hydride molecules and then applied to other systems. Calculated energies are compared with experimental thermodynamic and spectroscopic data for a set of forty-one mainly organic molecules representing a wide range of bonding environments. The most stringent test is based on a severely truncated virtual space in which higher spherical harmonic basis functions are removed. The errors of the initial CI calculations are large, but in each case, including defect corrections brings calculated CI energies into agreement with experimental values. The method is also applied to a NIST compilation of coupled-cluster calculations that employ a larger basis set and no truncation of the virtual space. The corrections show excellent consistency with total energies in very good agreement with experimental values. An extension of the method is applied to dmsn states of Sc, Ti, V, Mn, Cr, Fe, Co, Ni and Cu, significantly improving the agreement of calculated transition energies with spectroscopic values. △ Less

Submitted 12 May, 2022; originally announced May 2022.

Comments: 27 pages, 2 figures

Geologic context of the bright MARSIS reflectors in Ultimi Scopuli, South Polar Layered Deposits, Mars

Authors: M. E. Landis, J. L. Whitten

Abstract: Radar-bright basal reflectors have been detected below the South Polar Layered Deposits (SPLD), Mars using Advanced Radar for Subsurface and Ionosphere Sounding (MARSIS) data and have an exciting but controversial interpretation: liquid water from subglacial lakes. We mapped the surface of the SPLD immediately above and surrounding the putative lakes (1:2M map scale) in order to provide geologic c… ▽ More Radar-bright basal reflectors have been detected below the South Polar Layered Deposits (SPLD), Mars using Advanced Radar for Subsurface and Ionosphere Sounding (MARSIS) data and have an exciting but controversial interpretation: liquid water from subglacial lakes. We mapped the surface of the SPLD immediately above and surrounding the putative lakes (1:2M map scale) in order to provide geologic context for interpretation of the bright basal reflectors. We use THEMIS daytime IR (100 m/pixel), CTX (6 m/pixel), and HiRISE (25 cm/pixel) data to characterize geologic units and typical surface roughness. We find evidence for multiple geologic units with features due to CO2 and aeolian-related processes. We do not find evidence for surface modification linked to the postulated lake locations. This is not consistent with the interpretation of the MARSIS basal radar reflector as subglacial lakes. △ Less

Submitted 29 April, 2022; originally announced May 2022.

Comments: 29 pages, 2 figures (main paper), 4 (supplement), accepted 4/29/2022 at Geophysical Research Letters

Estimates of electron correlation based on density expansions

Authors: Jerry L. Whitten

Abstract: Methods for estimating the correlation energy of molecules and other electronic systems are discussed based on the assumption that the correlation energy can be partitioned between atomic regions. In one method, the electron density is expanded in terms of atomic contributions using rigorous electron repulsion bounds, and, in a second method, correlation contributions are associated with basis fun… ▽ More Methods for estimating the correlation energy of molecules and other electronic systems are discussed based on the assumption that the correlation energy can be partitioned between atomic regions. In one method, the electron density is expanded in terms of atomic contributions using rigorous electron repulsion bounds, and, in a second method, correlation contributions are associated with basis function pairs. The methods do not consider the detailed nature of localized excitations, but instead define a correlation energy per electron factor that that is unique to a specific atom. The correlation factors are basis function dependent and are determined by from configuration interaction calculations on diatomic and hydride molecules. The correlation energy estimates are compared with the results of high-level configuration interaction calculations for a test set of twenty-seven molecules representing a wide range of bonding environments (average error of 2.6%). An extension based on truncated CI calculations in which d- and hydrogen p-type functions are eliminated from the virtual space combined with estimates of dynamical correlation contributions using atomic correlation factors is discussed and applied to the dissociation of several molecules. △ Less

Submitted 28 September, 2020; originally announced September 2020.

Comments: 22 pages, 4 figures

Journal ref: J. Chem. Phys. 153, 244103 (2020)

Prediction of many-electron wavefunctions using atomic potentials: extended basis sets and molecular dissociation

Authors: Jerry L. Whitten

Abstract: A one-electron Schroedinger equation based on special one-electron potentials for atoms is shown to exist that produces orbitals for an arbitrary molecule that are sufficiently accurate to be used without modification to construct single- and multi-determinant wavefunctions. The exact Hamiltonian is used to calculate the energy variationally and to generate configuration interaction expansions. Ea… ▽ More A one-electron Schroedinger equation based on special one-electron potentials for atoms is shown to exist that produces orbitals for an arbitrary molecule that are sufficiently accurate to be used without modification to construct single- and multi-determinant wavefunctions. The exact Hamiltonian is used to calculate the energy variationally and to generate configuration interaction expansions. Earlier work on equilibrium geometries is extended to larger basis sets and molecular dissociation. For a test set of molecules representing different bonding environments, a single set of invariant atomic potentials gives wavefunctions with energies that deviate from configuration interaction energies based on SCF orbitals by less than 0.04 eV per bond or valence electron pair. On a single diagonalization of the Fock matrix, the corresponding errors are reduced 0.01 eV. Atomization energies are also in good agreement with CI values based on canonical SCF orbitals. Configuration interaction applications to single bond dissociations of water and glycine, and multiple bond dissociations of ethylene and oxygen produce dissociation energy curves in close agreement with CI calculations based on canonical SCF orbitals for the entire range of internuclear distances. △ Less

Submitted 12 September, 2019; originally announced September 2019.

Journal ref: Phys. Chem. Chem. Phys., 2019, 21, 21541

Prediction of many-electron wavefunctions using atomic potentials: refinements and extensions to transition metals and large systems

Authors: Jerry L. Whitten

Abstract: For a given many-electron molecule, it is possible to define a corresponding one-electron Schrödinger equation, using potentials derived from simple atomic densities, whose solution predicts fairly accurate molecular orbitals for single- and multi-determinant wavefunctions for the molecule. The energy is not predicted and must be evaluated by calculating Coulomb and exchange interactions over the… ▽ More For a given many-electron molecule, it is possible to define a corresponding one-electron Schrödinger equation, using potentials derived from simple atomic densities, whose solution predicts fairly accurate molecular orbitals for single- and multi-determinant wavefunctions for the molecule. The energy is not predicted and must be evaluated by calculating Coulomb and exchange interactions over the predicted orbitals. Transferable potentials for first-row atoms and transition metal oxides that can be used without modification in different molecules are reported. For improved accuracy, molecular wavefunctions can be refined by slightly scaling nuclear charges and by introducing potentials optimized for functional groups. For a test set of 20 molecules representing different bonding environments, the transferable potentials with scaling give wavefunctions with energies that deviate from exact self-consistent field or configuration interaction energies by less than 0.05 eV and 0.02 eV per bond or valence electron pair, respectively. Applications to the ground and excited states of a Ti18O36 nanoparticle and chlorophyll-s are reported. △ Less

Submitted 5 October, 2018; originally announced December 2018.

Comments: 20 pages. arXiv admin note: text overlap with arXiv:1702.06852

Journal ref: J. Chem. Phys. 150, 034107 (2019)

Method for including static correlation in molecules

Authors: Jerry L. Whitten

Abstract: New ways to treat electron correlation in electronic structure problems are discussed in the context of many-electron theory. The present work focuses primarily on static correlation. In related work, a method for including dynamical correlation effects is described. The overlap density of two basis functions i, j and the associated density matrix is a signature of bond formation and can be used t… ▽ More New ways to treat electron correlation in electronic structure problems are discussed in the context of many-electron theory. The present work focuses primarily on static correlation. In related work, a method for including dynamical correlation effects is described. The overlap density of two basis functions i, j and the associated density matrix is a signature of bond formation and can be used to define a local molecular orbital, i + j. The total electron density \r{ho} can be written in terms of densities derived from these two-center orbitals and residual one-center terms. In the interaction of total densities, the self-energy terms resulting from an average field (Hartree-Fock) Hamiltonian are allowed to respond to an explicit inclusion of electron repulsion by mixing (i + j)1(i + j)2 +λ(i - j)1(i - j)2 . The energy lowering weighted by the density matrix ij approximates this contribution to the correlation energy of the system. Numerical calculations for a set of 20 molecules representing different bonding environments are reported and results are compared with configuration interaction calculations using the same molecular orbital basis. Calculations on chlorin, N4C20H16, are reported as an example of how the method could be used in an embedding treatment of a large system. △ Less

Submitted 3 September, 2018; v1 submitted 31 August, 2018; originally announced August 2018.

Comments: 12 pages including two tables and two figures

Prediction of many-electron wavefunctions using atomic potentials

Authors: Fariba Nazari, Jerry L. Whitten

Abstract: For a given many-electron molecule, it is possible to define a corresponding one-electron Schrödinger equation, using potentials derived from simple atomic densities, whose solution predicts fairly accurate molecular orbitals for single- and multi-determinant wavefunctions for the molecule. The energy is not predicted and must be evaluated by calculating Coulomb and exchange interactions over the… ▽ More For a given many-electron molecule, it is possible to define a corresponding one-electron Schrödinger equation, using potentials derived from simple atomic densities, whose solution predicts fairly accurate molecular orbitals for single- and multi-determinant wavefunctions for the molecule. The energy is not predicted and must be evaluated by calculating Coulomb and exchange interactions over the predicted orbitals. Potentials are found by minimizing the energy of predicted wavefunctions. There exist slightly less accurate average potentials for first-row atoms that can be used without modification in different molecules. For a test set of molecules representing different bonding environments, these average potentials give wavefunctions with energies that deviate from exact self-consistent field or configuration interaction energies by less than 0.08 eV and 0.03 eV per bond or valence electron pair, respectively. △ Less

Submitted 2 May, 2017; v1 submitted 22 February, 2017; originally announced February 2017.

Comments: 14 pages

Journal ref: Journal of Chemical Physics 146, 194109 (2017)

Electron correlation by polarization of interacting densities

Authors: Jerry L. Whitten

Abstract: Coulomb interactions that occur in electronic structure calculations are correlated by allowing basis function components of the interacting densities to polarize, thereby reducing the magnitude of the interaction. Exchange integrals of molecular orbitals are not correlated. The modified Coulomb interactions are used in single-determinant or configuration interaction calculations. The objective is… ▽ More Coulomb interactions that occur in electronic structure calculations are correlated by allowing basis function components of the interacting densities to polarize, thereby reducing the magnitude of the interaction. Exchange integrals of molecular orbitals are not correlated. The modified Coulomb interactions are used in single-determinant or configuration interaction calculations. The objective is to account for dynamical correlation effects without explicitly introducing higher spherical harmonic functions into the molecular orbital basis. Molecular orbital densities are decomposed into a distribution of spherical components that conserve the charge and each of the interacting components is considered as a two-electron wavefunction embedded in the system acted on by an average field Hamiltonian plus . A method of avoiding redundancy is described. Applications to atoms, negative ions and molecules representing different types of bonding and spin states are discussed. △ Less

Submitted 2 May, 2017; v1 submitted 16 October, 2016; originally announced October 2016.

Journal ref: J. Chem. Phys. 146, 064113 (2017)