-
Readout of a quantum processor with high dynamic range Josephson parametric amplifiers
Authors:
T. C. White,
Alex Opremcak,
George Sterling,
Alexander Korotkov,
Daniel Sank,
Rajeev Acharya,
Markus Ansmann,
Frank Arute,
Kunal Arya,
Joseph C. Bardin,
Andreas Bengtsson,
Alexandre Bourassa,
Jenna Bovaird,
Leon Brill,
Bob B. Buckley,
David A. Buell,
Tim Burger,
Brian Burkett,
Nicholas Bushnell,
Zijun Chen,
Ben Chiaro,
Josh Cogan,
Roberto Collins,
Alexander L. Crook,
Ben Curtin
, et al. (69 additional authors not shown)
Abstract:
We demonstrate a high dynamic range Josephson parametric amplifier (JPA) in which the active nonlinear element is implemented using an array of rf-SQUIDs. The device is matched to the 50 $Ω$ environment with a Klopfenstein-taper impedance transformer and achieves a bandwidth of 250-300 MHz, with input saturation powers up to -95 dBm at 20 dB gain. A 54-qubit Sycamore processor was used to benchmar…
▽ More
We demonstrate a high dynamic range Josephson parametric amplifier (JPA) in which the active nonlinear element is implemented using an array of rf-SQUIDs. The device is matched to the 50 $Ω$ environment with a Klopfenstein-taper impedance transformer and achieves a bandwidth of 250-300 MHz, with input saturation powers up to -95 dBm at 20 dB gain. A 54-qubit Sycamore processor was used to benchmark these devices, providing a calibration for readout power, an estimate of amplifier added noise, and a platform for comparison against standard impedance matched parametric amplifiers with a single dc-SQUID. We find that the high power rf-SQUID array design has no adverse effect on system noise, readout fidelity, or qubit dephasing, and we estimate an upper bound on amplifier added noise at 1.6 times the quantum limit. Lastly, amplifiers with this design show no degradation in readout fidelity due to gain compression, which can occur in multi-tone multiplexed readout with traditional JPAs.
△ Less
Submitted 22 November, 2022; v1 submitted 16 September, 2022;
originally announced September 2022.
-
Effects of Laser-Annealing on Fixed-Frequency Superconducting Qubits
Authors:
Hyunseong Kim,
Christian Jünger,
Alexis Morvan,
Edward S. Barnard,
William P. Livingston,
M. Virginia P. Altoé,
Yosep Kim,
Chengyu Song,
Larry Chen,
John Mark Kreikebaum,
D. Frank Ogletree,
David I. Santiago,
Irfan Siddiqi
Abstract:
As superconducting quantum processors increase in complexity, techniques to overcome constraints on frequency crowding are needed. The recently developed method of laser-annealing provides an effective post-fabrication method to adjust the frequency of superconducting qubits. Here, we present an automated laser-annealing apparatus based on conventional microscopy components and demonstrate preserv…
▽ More
As superconducting quantum processors increase in complexity, techniques to overcome constraints on frequency crowding are needed. The recently developed method of laser-annealing provides an effective post-fabrication method to adjust the frequency of superconducting qubits. Here, we present an automated laser-annealing apparatus based on conventional microscopy components and demonstrate preservation of highly coherent transmons. In one case, we observe a two-fold increase in coherence after laser-annealing and perform noise spectroscopy on this qubit to investigate the change in defect features, in particular two-level system defects. Finally, we present a local heating model as well as demonstrate aging stability for laser-annealing on the wafer scale. Our work constitutes an important first step towards both understanding the underlying physical mechanism and scaling up laser-annealing of superconducting qubits.
△ Less
Submitted 7 June, 2022;
originally announced June 2022.
-
Observation of topological valley Hall edge states in honeycomb lattices of superconducting microwave resonators
Authors:
Alexis Morvan,
Mathieu Féchant,
Gianluca Aiello,
Julien Gabelli,
Jérôme Estève
Abstract:
We have designed honeycomb lattices for microwave photons with a frequency imbalance between the two sites in the unit cell. This imbalance is the equivalent of a mass term that breaks the lattice inversion symmetry. At the interface between two lattices with opposite imbalance, we observe topological valley edge states. By imaging the spatial dependence of the modes along the interface, we obtain…
▽ More
We have designed honeycomb lattices for microwave photons with a frequency imbalance between the two sites in the unit cell. This imbalance is the equivalent of a mass term that breaks the lattice inversion symmetry. At the interface between two lattices with opposite imbalance, we observe topological valley edge states. By imaging the spatial dependence of the modes along the interface, we obtain their dispersion relation that we compare to the predictions of an ab initio tight-binding model describing our microwave photonic lattices.
△ Less
Submitted 30 March, 2021; v1 submitted 30 March, 2021;
originally announced March 2021.
-
Bulk properties of honeycomb lattices of superconducting microwave resonators
Authors:
Alexis Morvan,
Mathieu Féchant,
Gianluca Aiello,
Julien Gabelli,
Jérôme Estève
Abstract:
We have realized different honeycomb lattices for microwave photons in the 4 to 8 GHz band using superconducting spiral resonators. Each lattice comprises a few hundred sites. Two designs have been studied, one leading to two bands touching at the Dirac points and one where a gap opens at the Dirac points. Using a scanning laser technique to image the eigenmodes of this new type of photonic lattic…
▽ More
We have realized different honeycomb lattices for microwave photons in the 4 to 8 GHz band using superconducting spiral resonators. Each lattice comprises a few hundred sites. Two designs have been studied, one leading to two bands touching at the Dirac points and one where a gap opens at the Dirac points. Using a scanning laser technique to image the eigenmodes of this new type of photonic lattices, we are able to reconstruct their band structure. The measured bands are in excellent agreement with ab initio models that combine numerical simulations of the electromagnetic properties of the spiral resonator and analytical calculations.
△ Less
Submitted 17 March, 2021;
originally announced March 2021.
-
Improving wafer-scale Josephson junction resistance variation in superconducting quantum coherent circuits
Authors:
J. M. Kreikebaum,
K. P. O'Brien,
A. Morvan,
I. Siddiqi
Abstract:
Quantum bits, or qubits, are an example of coherent circuits envisioned for next-generation computers and detectors. A robust superconducting qubit with a coherent lifetime of $O$(100 $μ$s) is the transmon: a Josephson junction functioning as a non-linear inductor shunted with a capacitor to form an anharmonic oscillator. In a complex device with many such transmons, precise control over each qubi…
▽ More
Quantum bits, or qubits, are an example of coherent circuits envisioned for next-generation computers and detectors. A robust superconducting qubit with a coherent lifetime of $O$(100 $μ$s) is the transmon: a Josephson junction functioning as a non-linear inductor shunted with a capacitor to form an anharmonic oscillator. In a complex device with many such transmons, precise control over each qubit frequency is often required, and thus variations of the junction area and tunnel barrier thickness must be sufficiently minimized to achieve optimal performance while avoiding spectral overlap between neighboring circuits. Simply transplanting our recipe optimized for single, stand-alone devices to wafer-scale (producing 64, 1x1 cm dies from a 150 mm wafer) initially resulted in global drifts in room-temperature tunneling resistance of $\pm$ 30%. Inferring a critical current $I_{\rm c}$ variation from this resistance distribution, we present an optimized process developed from a systematic 38 wafer study that results in $<$ 3.5% relative standard deviation (RSD) in critical current ($\equiv σ_{I_{\rm c}}/\left\langle I_{\rm c} \right\rangle$) for 3000 Josephson junctions (both single-junctions and asymmetric SQUIDs) across an area of 49 cm$^2$. Looking within a 1x1 cm moving window across the substrate gives an estimate of the variation characteristic of a given qubit chip. Our best process, utilizing ultrasonically assisted development, uniform ashing, and dynamic oxidation has shown $σ_{I_{\rm c}}/\left\langle I_{\rm c} \right\rangle$ = 1.8% within 1x1 cm, on average, with a few 1x1 cm areas having $σ_{I_{\rm c}}/\left\langle I_{\rm c} \right\rangle$ $<$ 1.0% (equivalent to $σ_{f}/\left\langle f \right\rangle$ $<$ 0.5%). Such stability would drastically improve the yield of multi-junction chips with strict critical current requirements.
△ Less
Submitted 7 May, 2020; v1 submitted 19 September, 2019;
originally announced September 2019.
