-
Entrainment into particle-laden turbulent plumes
Authors:
Craig D. McConnochie,
Claudia Cenedese,
Jim N. McElwaine
Abstract:
We use laboratory experiments to investigate the entrainment of ambient fluid into an axisymmetric turbulent plume that contains dense particles with a settling velocity that is considerably smaller than the plume velocity. We consider the effect of particle size, particle concentration, and the orientation of the plume buoyancy flux - either in the same or opposite direction to the particle buoya…
▽ More
We use laboratory experiments to investigate the entrainment of ambient fluid into an axisymmetric turbulent plume that contains dense particles with a settling velocity that is considerably smaller than the plume velocity. We consider the effect of particle size, particle concentration, and the orientation of the plume buoyancy flux - either in the same or opposite direction to the particle buoyancy flux. When the plume buoyancy flux is in the opposite direction to the particle buoyancy flux, entrainment into the plume increases by up to 40%. The rate of entrainment increases linearly with the ratio of particle buoyancy flux to fluid buoyancy flux but does not depend on the particle size. In contrast, when the plume buoyancy flux is in the same direction as the particle buoyancy flux, entrainment into the plume is unaffected by the addition of particles. The observed increase in entrainment, when the plume and particle buoyancy fluxes are in opposite directions, is consistent with inertial clustering whereby particles are ejected from regions of relatively high vorticity and accumulate in regions of relatively high strain rate within the turbulent flow field. Regions with high particle concentration can then experience convective instabilities that affect the entrainment of ambient fluid into the plume. The differing behaviour observed based on the plume buoyancy flux orientation is also consistent with the above mechanism. Finally, based on the laboratory findings, we propose a new expression for the entrainment coefficient to take into account the effect of suspended particles of opposing buoyancy flux to the plume buoyancy flux.
△ Less
Submitted 13 December, 2021; v1 submitted 2 September, 2021;
originally announced September 2021.
-
Surface expression of a wall fountain: application to subglacial discharge plumes
Authors:
Craig D. McConnochie,
Claudia Cenedese,
Jim N. McElwaine
Abstract:
We use laboratory experiments and theoretical modeling to investigate the surface expression of a subglacial discharge plume, as occurs at many fjords around Greenland. The experiments consider a fountain that is released vertically into a homogeneous fluid, adjacent either to a vertical or a sloping wall, that then spreads horizontally at the free surface before sinking back to the bottom. We pre…
▽ More
We use laboratory experiments and theoretical modeling to investigate the surface expression of a subglacial discharge plume, as occurs at many fjords around Greenland. The experiments consider a fountain that is released vertically into a homogeneous fluid, adjacent either to a vertical or a sloping wall, that then spreads horizontally at the free surface before sinking back to the bottom. We present a model that separates the fountain into two separate regions: a vertical fountain and a horizontal, negatively buoyant jet. The model is compared to laboratory experiments that are conducted over a range of volume fluxes, density differences, and ambient fluid depths. It is shown that the non-dimensionalised length, width, and aspect ratio of the surface expression are dependent on the Froude number, calculated at the start of the negatively buoyant jet. The model is applied to observations of the surface expression from a Greenland subglacial discharge plume. In the case where the discharge plume reaches the surface with negative buoyancy the model can be used to estimate the discharge properties at the base of the glacier.
△ Less
Submitted 1 March, 2020; v1 submitted 25 March, 2019;
originally announced March 2019.
-
Comments on avalanche flow models based on the concept of random kinetic energy
Authors:
Dieter Issler,
James T. Jenkins,
Jim N. McElwaine
Abstract:
In a series of papers, Bartelt and co-workers developed novel snow-avalanche models in which \emph{random kinetic energy} $R_K$ (a.k.a.\ granular temperature) is a key concept. The earliest models were for a single, constant density layer, using a Voellmy model but with $R_K$-dependent friction parameters. This was then extended to variable density, and finally a suspension layer (powder-snow clou…
▽ More
In a series of papers, Bartelt and co-workers developed novel snow-avalanche models in which \emph{random kinetic energy} $R_K$ (a.k.a.\ granular temperature) is a key concept. The earliest models were for a single, constant density layer, using a Voellmy model but with $R_K$-dependent friction parameters. This was then extended to variable density, and finally a suspension layer (powder-snow cloud) was added. The physical basis and mathematical formulation of these models is critically reviewed here, with the following main findings: (i) Key assumptions in the original RKE model differ substantially from established results on dense granular flows; in particular, the effective friction coefficient decreases to zero with velocity in the RKE model. (ii) In the variable-density model, non-canonical interpretation of the energy balance leads to a third-order evolution equation for the flow depth or density, whereas the stated assumptions imply a first-order equation. (iii) The model for the suspension layer neglects gravity and disregards well established theoretical and experimental results on particulate gravity currents. Some options for improving these aspects are discussed.
△ Less
Submitted 2 October, 2017;
originally announced October 2017.
-
Bulldozing of granular material
Authors:
A. Sauret,
N. J. Balmforth,
C. P. Caulfield,
J. N. McElwaine
Abstract:
We investigate the bulldozing motion of a granular sandpile driven forwards by a vertical plate. The problem is set up in the laboratory by emplacing the pile on a table rotating underneath a stationary plate; the continual circulation of the bulldozed material allows the dynamics to be explored over relatively long times, and the variation of the velocity with radius permits one to explore the de…
▽ More
We investigate the bulldozing motion of a granular sandpile driven forwards by a vertical plate. The problem is set up in the laboratory by emplacing the pile on a table rotating underneath a stationary plate; the continual circulation of the bulldozed material allows the dynamics to be explored over relatively long times, and the variation of the velocity with radius permits one to explore the dependence on bulldozing speed within a single experiment. We measure the time-dependent surface shape of the dune for a range of rotation rates, initial volumes and radial positions, for four granular materials, ranging from glass spheres to irregularly shaped sand. The evolution of the dune can be separated into two phases: a rapid initial adjustment to a state of quasi-steady avalanching perpendicular to the blade, followed by a much slower phase of lateral spreading and radial migration. The quasi-steady avalanching sets up a well-defined perpendicular profile with a nearly constant slope. This profile can be scaled by the depth against the bulldozer to collapse data from different times, radial positions and experiments onto common master curves that are characteristic of the granular material and depend on the local Froude number. The lateral profile of the dune along the face of the bulldozer varies more gradually with radial position, and evolves by slow lateral spreading. The spreading is asymmetrical, with the inward progress of the dune eventually arrested and its bulk migrating to larger radii. A one-dimensional depth-averaged model recovers the nearly linear perpendicular profile of the dune, but does not capture the finer nonlinear details of the master curves. A two-dimensional version of the model leads to an advection-diffusion equation that reproduces the lateral spreading and radial migration.
△ Less
Submitted 1 May, 2014;
originally announced May 2014.
-
Scaling and dynamics of washboard road
Authors:
Anne-Florence Bitbol,
Nicolas Taberlet,
Stephen W. Morris,
Jim N. McElwaine
Abstract:
Granular surfaces subjected to forces due to rolling wheels develop ripples above a critical speed. The resulting pattern, known as "washboard" or "corrugated" road, is common on dry, unpaved roads. We investigated this phenomenon theoretically and experimentally, using laboratory-scale apparatus and beds of dry sand. A thick layer of sand on a circular track was forced by a rolling wheel on an…
▽ More
Granular surfaces subjected to forces due to rolling wheels develop ripples above a critical speed. The resulting pattern, known as "washboard" or "corrugated" road, is common on dry, unpaved roads. We investigated this phenomenon theoretically and experimentally, using laboratory-scale apparatus and beds of dry sand. A thick layer of sand on a circular track was forced by a rolling wheel on an arm whose weight and moment of inertia could be varied. We compared the ripples made by the rolling wheel to those made using a simple inclined plow blade. We investigated the dependence of the critical speed on various parameters, and describe a scaling argument which leads to a dimensionless ratio, analogous to the hydrodynamic Froude number, which controls the instability. This represents the crossover between conservative, dynamic forces and dissipative, static forces. Above onset, wheel-driven ripples move in the direction of motion of the wheel, but plow-driven ripples move in the reverse direction for a narrow range of Froude numbers.
△ Less
Submitted 19 June, 2009; v1 submitted 26 March, 2009;
originally announced March 2009.
-
Washboard Road: The dynamics of granular ripples formed by rolling wheels
Authors:
Nicolas Taberlet,
Stephen W. Morris,
Jim N. McElwaine
Abstract:
Granular surfaces tend to develop lateral ripples under the action of surface forces exerted by rolling wheels, an effect known as washboard or corrugated road. We report the results of both laboratory experiments and soft-particle direct numerical simulations. Above a critical speed, the ripple pattern appears as small patches of traveling waves which eventually spread to the entire circumferen…
▽ More
Granular surfaces tend to develop lateral ripples under the action of surface forces exerted by rolling wheels, an effect known as washboard or corrugated road. We report the results of both laboratory experiments and soft-particle direct numerical simulations. Above a critical speed, the ripple pattern appears as small patches of traveling waves which eventually spread to the entire circumference. The ripples drift slowly in the driving direction. Interesting secondary dynamics of the saturated ripples were observed, as well as various ripple creation and destruction events. All of these effects are captured qualitatively by 2D soft particle simulations in which a disk rolls over a bed of poly-disperse particles in a periodic box. These simulations show that compaction and segregation are inessential to the ripple phenomenon. We also discuss a simplified scaling model which gives some insight into the mechanism of the instability.
△ Less
Submitted 24 November, 2007;
originally announced November 2007.
