Showing 1–8 of 8 results for author: Martemiyanov, A

Assessment of the potential of SiPM-based systems for bioluminescence detection

Authors: S. Lomazzi, M. Caccia, C. Distasi, M. Dionisi, D. Lim, A. Martemiyanov, L. Nardo, F. A. Ruffinatti, R. Santoro

Abstract: Bioluminescence detection requires single-photon sensitivity, extremely low detection limits and wide dynamic range. Such performances were traditionally assured by photomultiplier-tubes based systems. However, development of novel applications and industrialisation call for the introduction of more robust, compact and scalable devices. Silicon photomultipliers were recently put forward as the alt… ▽ More Bioluminescence detection requires single-photon sensitivity, extremely low detection limits and wide dynamic range. Such performances were traditionally assured by photomultiplier-tubes based systems. However, development of novel applications and industrialisation call for the introduction of more robust, compact and scalable devices. Silicon photomultipliers were recently put forward as the alternative to phototubes for a new generation of flexible and user friendly instruments. In this article, the figures of merit of a silicon-photomultiplier based system relying on a compact, low cost system are investigated. Possible implementations are proposed and a proof-of-principle bioluminescence measurement is performed. △ Less

Submitted 23 December, 2019; originally announced December 2019.

Test of SensL SiPM coated with NOL-1 wavelength shifter in liquid xenon

Authors: D. Yu. Akimov, V. A. Belov, O. V. Borshchev, A. A. Burenkov, Yu. L. Grishkin, A. K. Karelin, A. V. Kuchenkov, A. N. Martemiyanov, S. A. Ponomarenko, G. E. Simakov, V. N. Stekhanov, N. M. Surin, V. S. Timoshin, O. Ya. Zeldovich

Abstract: A SensL MicroFC-SMT-60035 6x6 mm$^2$ silicon photo-multiplier coated with a NOL-1 wavelength shifter have been tested in the liquid xenon to detect the 175-nm scintillation light. For comparison, a Hamamatsu vacuum ultraviolet sensitive MPPC VUV3 3x3 mm$^2$ was tested under the same conditions. The photodetection efficiency of $13.1 \pm 2.5$% and $6.0 \pm 1.0$%, correspondingly, is obtained. A SensL MicroFC-SMT-60035 6x6 mm$^2$ silicon photo-multiplier coated with a NOL-1 wavelength shifter have been tested in the liquid xenon to detect the 175-nm scintillation light. For comparison, a Hamamatsu vacuum ultraviolet sensitive MPPC VUV3 3x3 mm$^2$ was tested under the same conditions. The photodetection efficiency of $13.1 \pm 2.5$% and $6.0 \pm 1.0$%, correspondingly, is obtained. △ Less

Submitted 3 May, 2017; v1 submitted 5 April, 2017; originally announced April 2017.

Comments: 8 pages, 4 figures

An Educational Kit Based on a Modular Silicon Photomultiplier System

Authors: V. Arosio, M. Caccia, V. Chmill, A. Ebolese, A. Martemiyanov, F. Risigo, R. Santoro, M. Locatelli, M. Pieracci, C. Tintori

Abstract: Silicon Photo-Multipliers (SiPM) are state of the art light detectors with unprecedented single photon sensitivity and photon number resolving capability, representing a breakthrough in several fundamental and applied Science domains. An educational experiment based on a SiPM set-up is proposed in this article, guiding the student towards a comprehensive knowledge of this sensor technology while e… ▽ More Silicon Photo-Multipliers (SiPM) are state of the art light detectors with unprecedented single photon sensitivity and photon number resolving capability, representing a breakthrough in several fundamental and applied Science domains. An educational experiment based on a SiPM set-up is proposed in this article, guiding the student towards a comprehensive knowledge of this sensor technology while experiencing the quantum nature of light and exploring the statistical properties of the light pulses emitted by a LED. △ Less

Submitted 30 June, 2014; v1 submitted 16 August, 2013; originally announced August 2013.

Long-term operation of a multi-channel cosmic muon system based on scintillation counters with MRS APD light readout

Authors: A. Akindinov, V. Golovin, E. Grigoriev, Yu. Grishuk, S. Kuleshov, D. Malkevich, A. Martemiyanov, A. Nedosekin, M. Ryabinin, K. Voloshin

Abstract: A Cosmic Ray Test Facility (CRTF) is the first large-scale implementation of a scintillation triggering system based on a new scintillation technique known as START. In START, the scintillation light is collected and transported by WLS optical fibers, while light detection is performed by pairs of avalanche photodiodes with the Metal-Resistor-Semiconductor structure operated in the Geiger mode (… ▽ More A Cosmic Ray Test Facility (CRTF) is the first large-scale implementation of a scintillation triggering system based on a new scintillation technique known as START. In START, the scintillation light is collected and transported by WLS optical fibers, while light detection is performed by pairs of avalanche photodiodes with the Metal-Resistor-Semiconductor structure operated in the Geiger mode (MRS APD). START delivers 100% efficiency of cosmic muon detection, while its intrinsic noise level is less than 10^{-2} Hz. CRTF, consisting of 160 START channels, has been continuously operated by the ALICE TOF collaboration for more than 25 000 hours, and has demonstrated a high level of stability. Fewer than 10% of MRS APDs had to be replaced during this period. △ Less

Submitted 19 September, 2008; originally announced September 2008.

Comments: Proceedings of NDIP-2008. 8 pages, 8 figures, 6 references

Journal ref: Nucl.Instrum.Meth.A610:431-435,2009

START as the detector of choice for large-scale muon triggering systems

Authors: A. Akindinov, G. Bondarenko, V. Golovin, E. Grigoriev, Yu. Grishuk, D. Mal'kevich, A. Martemiyanov, A. Nedosekin, M. Ryabinin, V. Sheinkman, A. Smirnitskiy, K. Voloshin

Abstract: Further progress in building high-granular large-scale systems based on Scintillation Tiles with MRS APD light readout (START) became possible thanks to the creation of an improved version of MRS APD. The cost of the system may now be significantly reduced by using inexpensive extruded scintillator. More than 160 START samples were assembled based on this design modification and proved to posses… ▽ More Further progress in building high-granular large-scale systems based on Scintillation Tiles with MRS APD light readout (START) became possible thanks to the creation of an improved version of MRS APD. The cost of the system may now be significantly reduced by using inexpensive extruded scintillator. More than 160 START samples were assembled based on this design modification and proved to possess 100% MIP detection efficiency and the intrinsic noise rate of less than 0.08 Hz. Long-term stability of START characteristics was confirmed after 3.5 months of operation. △ Less

Submitted 24 May, 2006; originally announced May 2006.

Comments: 7 pages, 2 figures, reported at the 4th International Conference on New Developments in Photodetection, Beaune, France, June 19-24, 2005

Journal ref: Nucl.Instrum.Meth.A567:74-77,2006

Scintillation counter with MRS APD light readout

Authors: A. Akindinov, G. Bondarenko, V. Golovin, E. Grigoriev, Yu. Grishuk, D. Mal'kevich, A. Martemiyanov, M. Ryabinin, A. Smirnitskiy, K. Voloshin

Abstract: START, a high-efficiency and low-noise scintillation detector for ionizing particles, was developed for the purpose of creating a high-granular system for triggering cosmic muons. Scintillation light in START is detected by MRS APDs (Avalanche Photo-Diodes with Metal-Resistance-Semiconductor structure), operated in the Geiger mode, which have 1 mm^2 sensitive areas. START is assembled from a 15… ▽ More START, a high-efficiency and low-noise scintillation detector for ionizing particles, was developed for the purpose of creating a high-granular system for triggering cosmic muons. Scintillation light in START is detected by MRS APDs (Avalanche Photo-Diodes with Metal-Resistance-Semiconductor structure), operated in the Geiger mode, which have 1 mm^2 sensitive areas. START is assembled from a 15 x 15 x 1 cm^3 scintillating plastic plate, two MRS APDs and two pieces of wavelength-shifting optical fiber stacked in circular coils inside the plastic. The front-end electronic card is mounted directly on the detector. Tests with START have confirmed its operational consistency, over 99% efficiency of MIP registration and good homogeneity. START demonstrates a low intrinsic noise of about 10^{-2} Hz. If these detectors are to be mass-produced, the cost of a mosaic array of STARTs is estimated at a moderate level of 2-3 kUSD/m^2. △ Less

Submitted 27 March, 2006; originally announced March 2006.

Comments: 6 pages, 5 figures

Journal ref: Nucl.Instrum.Meth. A539 (2005) 172-176

100 ps time-of-flight resolution of Dielectric Resistive Plate Chamber

Authors: A. Akindinov, V. Golovin, A. Martemiyanov, V. Petrov, V. Plotnikov, A. Smirnitsky, K. Voloshin

Abstract: Time of flight of a minimum ionizing particle along a fixed base has been measured with a 100 ps accuracy by means of a Dielectric Resistive Plate Chamber (DRPC) with 4 x 0.3 mm gas gaps. DRPC timing characteristics have been studied with different applied voltages, discriminating thresholds and beam intensities. It may be stated that the time-of-flight resolution of gaseous detectors developed… ▽ More Time of flight of a minimum ionizing particle along a fixed base has been measured with a 100 ps accuracy by means of a Dielectric Resistive Plate Chamber (DRPC) with 4 x 0.3 mm gas gaps. DRPC timing characteristics have been studied with different applied voltages, discriminating thresholds and beam intensities. It may be stated that the time-of-flight resolution of gaseous detectors developed within the ALICE experiment has reached the level of the best known scintillation counters. △ Less

Submitted 21 February, 2005; originally announced February 2005.

Comments: 5 pages, 7 figures

Report number: Preprint ITEP 20-99

Dielectric Resistive Plate Chamber as a detector for time-of-flight measurements

Authors: A. Akindinov, V. Golovin, A. Martemiyanov, V. Petrov, A. Smirnitskiy, K. Voloshin

Abstract: Principles of operation, construction and first test results of a Dielectric Resistive Plate Chamber (DRPC) are described. The detector has shown stability of operation in the avalanche mode of gas amplfication within a wide range of applied voltages. Double-gap DRPCs have demonstrated the MIP registration efficiency of 97% and the time resolution of 180-200 ps. No changes in DRPC operation have… ▽ More Principles of operation, construction and first test results of a Dielectric Resistive Plate Chamber (DRPC) are described. The detector has shown stability of operation in the avalanche mode of gas amplfication within a wide range of applied voltages. Double-gap DRPCs have demonstrated the MIP registration efficiency of 97% and the time resolution of 180-200 ps. No changes in DRPC operation have been observed with test beam intensities up to 10^3 Hz/cm^2. △ Less

Submitted 2 December, 2004; v1 submitted 15 October, 2004; originally announced October 2004.

Comments: 8 pages, 7 figures text formatting and figures updated for better performance slight corrections made in the text

Report number: ITEP 45 98