X-ray particle tracking velocimetry for rheological characterization: Application to material extrusion additive manufacturing
Authors:
Julian Kattinger,
Stefan Hiemer,
Mike Kornely,
Julian Ehrler,
Phi-Long Chung,
Christian Bonten,
Marc Kreutzbruck
Abstract:
We introduce X-ray Particle Tracking Velocimetry (XPTV) as a promising method to quantitatively resolve the velocity field and associated rheological quantities of polymer melt flow within the nozzle of a fused filament fabrication (FFF) printer. Employing tungsten powder as tracer particles embedded within a polymer filament, we investigate melt flow dynamics through an aluminum nozzle in a custo…
▽ More
We introduce X-ray Particle Tracking Velocimetry (XPTV) as a promising method to quantitatively resolve the velocity field and associated rheological quantities of polymer melt flow within the nozzle of a fused filament fabrication (FFF) printer. Employing tungsten powder as tracer particles embedded within a polymer filament, we investigate melt flow dynamics through an aluminum nozzle in a custom-designed experimental setup, based on commercial designs. The velocity profiles obtained via XPTV reveal significant deviations from classical Newtonian flow, highlighting complex heterogeneous and non-isothermal behavior within the melt. From these measurements, we determine the local infinitesimal strain rate tensor and correlate flow-induced non-Newtonian effects to spatially varying temperature distributions, reflecting incomplete thermal homogenization within the nozzle. Our findings demonstrate the capability of XPTV to quantify both velocity fields and rheological properties, underscoring its potential as a future tool for investigating opaque polymer melt flows in additive manufacturing, industrial processing, and rheology. To our knowledge, this represents the first reported application of XPTV in polymer melt rheology, offering a new approach to address measurement challenges previously inaccessible to conventional optical methods.
△ Less
Submitted 7 April, 2025;
originally announced April 2025.
Analysis of melting and flow in the hot-end of a material extrusion 3D printer using X-ray computed tomography
Authors:
Julian Kattinger,
Mike Kornely,
Julian Ehrler,
Christian Bonten,
Marc Kreutzbruck
Abstract:
This paper presents in-situ X-ray computed tomography (CT) experiments used to study the flow behavior within a conventional hot-end of a fused filament fabrication printer. Three types of experiments were performed to better understand the melt and flow behavior. In one experiment, 360° CT scans were conducted, focusing on the air gap between the filament and the nozzle wall. In a second experime…
▽ More
This paper presents in-situ X-ray computed tomography (CT) experiments used to study the flow behavior within a conventional hot-end of a fused filament fabrication printer. Three types of experiments were performed to better understand the melt and flow behavior. In one experiment, 360° CT scans were conducted, focusing on the air gap between the filament and the nozzle wall. In a second experiment, the flow profile inside the nozzle was studied using radiography. To provide a good contrast to the surrounding nozzle material, filament was prepared containing small amounts of tungsten powder as a contrast agent. During a third test, the extruder forces were measured and compared with the X-ray results and the predictions of a numerical simulation. The CT scans showed that at higher filament speeds, less area of the nozzle wall is in contact with the melt. This means that a larger part of the barrel section is occupied by an air gap between the solid filament and the nozzle wall. In contrast to the filament speed, the influence of the heater temperature shows no discernible effect on the part of the nozzle filled with melt. Radiographic evaluation of the velocity profile revealed a parabolic distribution under the studied conditions, closely matching numerical simulations modeling the flow as isothermal and non-Newtonian. The study's findings offer potential for improving nozzle design. Furthermore, the presented experimental method can serve as a valuable tool for future validation of more complex numerical simulations.
△ Less
Submitted 25 August, 2023;
originally announced August 2023.
