-
Three-Dimensional Reconstructions of Coronal Wave Surfaces Using a New Mask-Fitting Method
Authors:
Li Feng,
Lei Lu,
Bernd Inhester,
Joseph Plowman,
Beili Ying,
Marilena Mierla,
Matthew J. West,
Weiqun Gan
Abstract:
Coronal waves are large-scale disturbances often driven by coronal mass ejections (CMEs). We investigate a spectacular wave event on 7 March 2012, which is associated with an X5.4 flare (SOL2012-03-07). By using a running center-median (RCM) filtering method for the detection of temporal variations in extreme ultraviolet (EUV) images, we enhance the EUV disturbance observed by the Atmospheric Imag…
▽ More
Coronal waves are large-scale disturbances often driven by coronal mass ejections (CMEs). We investigate a spectacular wave event on 7 March 2012, which is associated with an X5.4 flare (SOL2012-03-07). By using a running center-median (RCM) filtering method for the detection of temporal variations in extreme ultraviolet (EUV) images, we enhance the EUV disturbance observed by the Atmospheric Imaging Assembly (AIA) onboard the Solar Dynamics Observatory (SDO) and the Sun Watcher using Active Pixel System detector and Image Processing (SWAP) onboard the PRoject for Onboard Autonomy 2 (PROBA2). In coronagraph images, a halo front is observed to be the upper counterpart of the EUV disturbance. Based on the EUV and coronagraph images observed from three different perspectives, we have made three-dimensional (3D) reconstructions of the wave surfaces using a new mask-fitting method. The reconstructions are compared with those obtained from forward-fitting methods. We show that the mask fitting method can reflect the inhomogeneous coronal medium by capturing the concave shape of the shock wave front. Subsequently, we trace the developing concave structure and derive the deprojected wave kinematics. The speed of the 3D-wave nose increases from a low value below a few hundred $\mathrm{km\,s^{-1}}$ to a maximum value of about 3800 $\mathrm{km\,s^{-1}}$, and then slowly decreases afterwards. The concave structure starts to decelerate earlier and has significantly lower speeds than those of the wave nose. We also find that the 3D-wave in the extended corona has a much higher speed than the speed of EUV disturbances across the solar disk.
△ Less
Submitted 22 September, 2020;
originally announced September 2020.
-
Initiation and Early Kinematic Evolution of Solar Eruptions
Authors:
X. Cheng,
J. Zhang,
B. Kliem,
T. {Török},
C. Xing,
Z. J. Zhou,
B. Inhester,
M. D. Ding
Abstract:
We investigate the initiation and early evolution of 12 solar eruptions, including six active region hot channel and six quiescent filament eruptions, which were well observed by the \textsl{Solar Dynamics Observatory}, as well as by the \textsl{Solar TErrestrial RElations Observatory} for the latter. The sample includes one failed eruption and 11 coronal mass ejections, with velocities ranging fr…
▽ More
We investigate the initiation and early evolution of 12 solar eruptions, including six active region hot channel and six quiescent filament eruptions, which were well observed by the \textsl{Solar Dynamics Observatory}, as well as by the \textsl{Solar TErrestrial RElations Observatory} for the latter. The sample includes one failed eruption and 11 coronal mass ejections, with velocities ranging from 493 to 2140~km~s$^{-1}$. A detailed analysis of the eruption kinematics yields the following main results. (1) The early evolution of all events consists of a slow-rise phase followed by a main-acceleration phase, the height-time profiles of which differ markedly and can be best fit, respectively, by a linear and an exponential function. This indicates that different physical processes dominate in these phases, which is at variance with models that involve a single process. (2) The kinematic evolution of the eruptions tends to be synchronized with the flare light curve in both phases. The synchronization is often but not always close. A delayed onset of the impulsive flare phase is found in the majority of the filament eruptions (5 out of 6). This delay, and its trend to be larger for slower eruptions, favor ideal MHD instability models. (3) The average decay index at the onset heights of the main acceleration is close to the threshold of the torus instability for both groups of events (although based on a tentative coronal field model for the hot channels), suggesting that this instability initiates and possibly drives the main acceleration.
△ Less
Submitted 7 April, 2020;
originally announced April 2020.
-
Comparison of CME/shock propagation models with heliospheric imaging and in situ observations
Authors:
Xinhua Zhao,
Ying D. Liu,
Bernd Inhester,
Xueshang Feng,
Thomas Wiegelmann,
Lei Lu
Abstract:
The prediction of the arrival time for fast coronal mass ejections (CMEs) and their associated shocks is highly desirable in space weather studies. In this paper, we use two shock propagation models, i.e. Data Guided Shock Time Of Arrival (DGSTOA) and Data Guided Shock Propagation Model (DGSPM), to predict the kinematical evolution of interplanetary shocks associated with fast CMEs. DGSTOA is base…
▽ More
The prediction of the arrival time for fast coronal mass ejections (CMEs) and their associated shocks is highly desirable in space weather studies. In this paper, we use two shock propagation models, i.e. Data Guided Shock Time Of Arrival (DGSTOA) and Data Guided Shock Propagation Model (DGSPM), to predict the kinematical evolution of interplanetary shocks associated with fast CMEs. DGSTOA is based on the similarity theory of shock waves in the solar wind reference frame, and DGSPM on the non-similarity theory in the stationary reference frame. The inputs are the kinematics of the CME front at the maximum speed moment obtained from the geometric triangulation method applied to STEREO imaging observations together with the Harmonic Mean approximation. The outputs provide the subsequent propagation of the associated shock. We apply these models to the CMEs on 2012 January 19, January 23, and March 7. We find that the shock models predict reasonably well the shock's propagation after the impulsive acceleration. The shock's arrival time and local propagation speed at Earth predicted by these models are consistent with in situ measurements of WIND. We also employ the Drag-Based Model (DBM) as a comparison, and find that it predicts a steeper deceleration than the shock models after the rapid deceleration phase. The predictions of DBM at 1 AU agree with the following ICME or sheath structure, not the preceding shock. These results demonstrate the applicability of the shock models used here for future arrival time prediction of interplanetary shocks associated with fast CMEs.
△ Less
Submitted 19 July, 2016;
originally announced July 2016.
-
Why does the apparent mass of a coronal mass ejection increase?
Authors:
Li Feng,
Yuming Wang,
Fang Shen,
Chenglong Shen,
Bernd Inhester,
Lei Lu,
Weiqun Gan
Abstract:
Mass is one of the most fundamental parameters characterizing the dynamics of a coronal mass ejection (CME). It has been found that CME apparent mass measured from the brightness enhancement in coronagraph images shows an increasing trend during its evolution in the corona. However, the physics behind it is not clear. Does the apparent mass gain come from the mass outflow from the dimming regions…
▽ More
Mass is one of the most fundamental parameters characterizing the dynamics of a coronal mass ejection (CME). It has been found that CME apparent mass measured from the brightness enhancement in coronagraph images shows an increasing trend during its evolution in the corona. However, the physics behind it is not clear. Does the apparent mass gain come from the mass outflow from the dimming regions in the low corona, or from the pileup of the solar wind plasma around the CME when it propagates outwards from the Sun? We analyzed the mass evolution of six CME events. Their mass can increase by a factor of 1.6 to 3.2 from 4 to 15 Rs in the field of view (FOV) of the coronagraph on board the Solar Terrestrial Relations Observatory (STEREO). Over the distance about 7 to 15 Rs, where the coronagraph occulting effect can be negligible, the mass can increase by a factor of 1.3 to 1.7. We adopted the `snow-plough' model to calculate the mass contribution of the piled-up solar wind in the height range from about 7 to 15 Rs. For 2/3 of the events, the solar wind pileup is not sufficient to explain the measured mass increase. In the height range from about 7 to 15 Rs, the ratio of the modeled to the measured mass increase is roughly larger than 0.55. Although the ratios are believed to be overestimated, the result gives evidence that the solar wind pileup probably makes a non-negligible contribution to the mass increase. It is not clear yet whether the solar wind pileup is a major contributor to the final mass derived from coronagraph observations. However, our study suggests that the solar wind pileup plays increasingly important role in the mass increase as a CME moves further away from the Sun.
△ Less
Submitted 7 September, 2015;
originally announced September 2015.
-
2D and 3D Polar Plume Analysis from the Three Vantage Positions of STEREO/EUVI A, B, and SOHO/EIT
Authors:
Judith de Patoul,
Bernd Inhester,
Li Feng,
Thomas Wiegelmann
Abstract:
Polar plumes are seen as elongated objects starting at the solar polar regions. Here, we analyze these objects from a sequence of images taken simultaneously by the three spacecraft telescopes STEREO/EUVI A and B, and SOHO/EIT. We establish a method capable of automatically identifying plumes in solar EUV images close to the limb at 1.01 - 1.39 R in order to study their temporal evolution. This pl…
▽ More
Polar plumes are seen as elongated objects starting at the solar polar regions. Here, we analyze these objects from a sequence of images taken simultaneously by the three spacecraft telescopes STEREO/EUVI A and B, and SOHO/EIT. We establish a method capable of automatically identifying plumes in solar EUV images close to the limb at 1.01 - 1.39 R in order to study their temporal evolution. This plume-identification method is based on a multiscale Hough-wavelet analysis. Then two methods to determined their 3D localization and structure are discussed: First, tomography using the filtered back-projection and including the differential rotation of the Sun and, secondly, conventional stereoscopic triangulation. We show that tomography and stereoscopy are complementary to study polar plumes. We also show that this systematic 2D identification and the proposed methods of 3D reconstruction are well suited, on one hand, to identify plumes individually and on the other hand, to analyze the distribution of plumes and inter-plume regions. Finally, the results are discussed focusing on the plume position with their cross-section area.
△ Less
Submitted 17 November, 2011;
originally announced November 2011.
-
Solar magnetism eXplorer (SolmeX)
Authors:
H. Peter,
L. Abbo,
V. Andretta,
F. Auchere,
A. Bemporad,
F. Berrilli,
V. Bommier,
A. Braukhane,
R. Casini,
W. Curdt,
J. Davila,
H. Dittus,
S. Fineschi,
A. Fludra,
A. Gandorfer,
D. Griffin,
B. Inhester,
A. Lagg,
E. Landi Degl'Innocenti,
V. Maiwald,
R. Manso Sainz,
V. Martinez Pillet,
S. Matthews,
D. Moses,
S. Parenti
, et al. (14 additional authors not shown)
Abstract:
The magnetic field plays a pivotal role in many fields of Astrophysics. This is especially true for the physics of the solar atmosphere. Measuring the magnetic field in the upper solar atmosphere is crucial to understand the nature of the underlying physical processes that drive the violent dynamics of the solar corona -- that can also affect life on Earth.
SolmeX, a fully equipped solar space o…
▽ More
The magnetic field plays a pivotal role in many fields of Astrophysics. This is especially true for the physics of the solar atmosphere. Measuring the magnetic field in the upper solar atmosphere is crucial to understand the nature of the underlying physical processes that drive the violent dynamics of the solar corona -- that can also affect life on Earth.
SolmeX, a fully equipped solar space observatory for remote-sensing observations, will provide the first comprehensive measurements of the strength and direction of the magnetic field in the upper solar atmosphere. The mission consists of two spacecraft, one carrying the instruments, and another one in formation flight at a distance of about 200m carrying the occulter to provide an artificial total solar eclipse. This will ensure high-quality coronagraphic observations above the solar limb.
Solmex integrates two spectro-polarimetric coronagraphs for off-limb observations, one in the EUV and one in the IR, and three instruments for observations on the disk. The latter comprises one imaging polarimeter in the EUV for coronal studies, a spectro-polarimeter in the EUV to investigate the low corona, and an imaging spectro-polarimeter in the UV for chromospheric studies.
SOHO and other existing missions have investigated the emission of the upper atmosphere in detail (not considering polarization), and as this will be the case also for missions planned for the near future. Therefore it is timely that SolmeX provides the final piece of the observational quest by measuring the magnetic field in the upper atmosphere through polarimetric observations.
△ Less
Submitted 26 August, 2011;
originally announced August 2011.
