Showing 1–2 of 2 results for author: Hola, M

Characterising and tackling thermally induced zero-drift in displacement measuring interferometry using temperature-controlled enclosure

Authors: Simon Rerucha, Miroslava Hola, Ondrej Cip, Josef Lazar, Jindrich Oulehla, Bretislav Mikel

Abstract: Our research efforts in displacement measurement interferometry focused on long-term drifts initiated an extended experimental investigation in the interferometric assemblies of our design. We aimed to analyze, characterize and tackle the long-term measurement stability, expressed as the zero-drift, with particular attention to the thermal effects. For the experimentation, we developed a thermosta… ▽ More Our research efforts in displacement measurement interferometry focused on long-term drifts initiated an extended experimental investigation in the interferometric assemblies of our design. We aimed to analyze, characterize and tackle the long-term measurement stability, expressed as the zero-drift, with particular attention to the thermal effects. For the experimentation, we developed a thermostatic chamber equipped with active temperature regulation, an array of sensors and control electronics. With either the finely stabilized temperature or with the thermal cycling, we can carry out a range of investigations: verification of modified design or prototype interferometers, testing of production pieces, characterization of integrated assemblies and units in terms of the zero drift and the susceptibility to thermal effects -- the temperature sensitivity ($δL / δT$, expressed in nm.K$^{-1}$). With these experimental studies, we demonstrate the potential of the zero drift studies to contribute to the development and broader expansion of interferometric instrumentation. △ Less

Submitted 12 August, 2024; v1 submitted 9 April, 2024; originally announced April 2024.

Comments: 23 pages, 2 tables, 9 figures. Published in Measurement Science and Technology. Note: This is the version of the article before peer review or editing, as submitted by an author to Measurement Science and Technology. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it

Journal ref: Meas. Sci. Technol. 35 115011 (2024)

Linearized and Compensated Interferometric System for High-Velocity Traceable Length Calibration on a Metre Scale

Authors: Simon Rerucha, Bretislav Mikel, Zdenek Matej, Ondrej Herman, Miroslava Hola, Michal Jelinek, Petr Jedlicka, Ondrej Cip, Josef Lazar

Abstract: We report on a traceable calibration system for a 3500mm-long console that carries a measurement system for inspecting the diameter of a circular reactor chassis. The system uses two single-pass laser interferometers with homodyne fringe detection for measurement in two degrees of freedom. The hybrid FPGA-microcontroller control module carries out the fringe detection together with the application… ▽ More We report on a traceable calibration system for a 3500mm-long console that carries a measurement system for inspecting the diameter of a circular reactor chassis. The system uses two single-pass laser interferometers with homodyne fringe detection for measurement in two degrees of freedom. The hybrid FPGA-microcontroller control module carries out the fringe detection together with the application-specific scale linearization approach and the compensation of environmental influences such as thermal elongation and the refractive index of air fluctuations. We demonstrated the system feasibility with an accuracy of a few microns and translation velocity higher than 0:1 metre per second. △ Less

Submitted 2 May, 2019; originally announced May 2019.

Comments: CPS 2018, Lednice, CZ, September 2018 7 pages, 8 figures

Journal ref: Proc. SPIE 10976, 21st Czech-Polish-Slovak Optical Conference on Wave and Quantum Aspects of Contemporary Optics, 2018