Showing 1–2 of 2 results for author: Ki, W
-
Polyimide-Based Flexible Coupled-Coils Design and Load-Shift Keying Analysis
Authors:
Yuan Yao,
Wing-Hung Ki,
Chi-Ying Tsui
Abstract:
Wireless power transfer using inductive coupling is commonly used for medical implantable devices. The design of the secondary coil on the implantable device is important as it will affect the power transfer efficiency, the size of the implant, and also the data transmission between the implant and the in-vitro controller. In this paper, we present a design of the secondary coil on a polyimide-bas…
▽ More
Wireless power transfer using inductive coupling is commonly used for medical implantable devices. The design of the secondary coil on the implantable device is important as it will affect the power transfer efficiency, the size of the implant, and also the data transmission between the implant and the in-vitro controller. In this paper, we present a design of the secondary coil on a polyimide-based flexible substrate to achieve high power transfer efficiency. Load shift keying modulation is used for the data communication between the primary and secondary coils. A thorough analysis is done for the ideal and practical scenario and it shows that a mismatched secondary LC tank will affect the communication range and communication correctness. A solution to achieve robust data transmission is proposed and then verified by SPICE simulations.
△ Less
Submitted 1 February, 2021;
originally announced February 2021.
-
Investigation of On-Chip Inductors for Fully Integrated DC-DC Converters
Authors:
Nan Xu,
Wing-Hung Ki
Abstract:
On-silicon inductors using a bulk 0.18 μm CMOS process have been designed. By shunting different metal layers in parallel, inductor values and quality factors were simulated. Selected inductors were then employed in two open-loop buck converters for comparison: the first used an off-chip discrete diode, and the second used an on-chip active diode. All inductors and converters were sent for fabrica…
▽ More
On-silicon inductors using a bulk 0.18 μm CMOS process have been designed. By shunting different metal layers in parallel, inductor values and quality factors were simulated. Selected inductors were then employed in two open-loop buck converters for comparison: the first used an off-chip discrete diode, and the second used an on-chip active diode. All inductors and converters were sent for fabrication. The fabricated inductors were then measured to have values more than 250 nH over a wide range of frequency, validating the simulation results. The buck converters were switched at 30 MHz with a fixed duty ratio of 0.5, to generate an output voltage of 1.2 V from an input voltage of 2.4 V. The peak efficiency was measured to be 69.1% for a light load current of 12.9 mA.
△ Less
Submitted 20 August, 2019;
originally announced September 2019.
