-
An Asymmetric Spoof-Fluid-Spoof Acoustic Waveguide and its Application as a CO$_2$ Sensor
Authors:
Nathan Perchikov,
Đorđe Vujić,
Branimir Bajac,
Andrea Alù,
Vesna Bengin,
Nikolina Janković
Abstract:
We study pressure acoustic propagation in asymmetric spoof-fluid-spoof acoustic waveguides and its potential application in acoustic gas sensors. First, a stable and efficient analytical method is established for fast calculation of the dispersion curves based on spectral expansion and enforcement of continuity between segments at suitable collocation points. The analysis is validated by a commerc…
▽ More
We study pressure acoustic propagation in asymmetric spoof-fluid-spoof acoustic waveguides and its potential application in acoustic gas sensors. First, a stable and efficient analytical method is established for fast calculation of the dispersion curves based on spectral expansion and enforcement of continuity between segments at suitable collocation points. The analysis is validated by a commercial finite element software. The geometric design of the waveguide is then optimized for the emergence of a nearly-flat dispersion curve associated with vertical geometric asymmetry. The waveguide is fabricated using 3D printing technology and the measurement results corroborate the numerical simulations. Based on the nearly-flat dispersion curve supported by this waveguide, a CO$_2$ sensor is proposed allowing to relate the phase difference measured between two points in the waveguide to the composition of the gas in the waveguide. The proposed sensor is experimentally validated in a controlled environment and the measurement results match the computational predictions well. The sensor is robust with respect to noise and signal-recording duration due to fast phase measurements and shows high sensitivity to gas concentration due to reliance on the second, nearly-flat, dispersion curve. In addition, the sensor is label-free and low-cost, while exhibiting rapid response, low-maintenance requirements and potential for measurements in a wide range of CO$_2$ concentrations without saturation issues.
△ Less
Submitted 25 October, 2023; v1 submitted 27 April, 2023;
originally announced May 2023.
-
Network-Reconfiguration-Aware Power Oscillation Damping Controller for Newly Commissioned Converter-Interfaced Power Plants
Authors:
Njegos Jankovic,
Javier Roldan-Perez,
Milan Prodanovic,
Jon Are Suul,
Salvatore D'Arco,
Luis Rouco-Rodriguez
Abstract:
In recent years, transmission system operators have started requesting converter-interfaced generators (CIGs) to participate in grid services such as power oscillation damping (POD). As power systems are prone to topology changes because of connection and disconnection of generators and electrical lines, one of the most important requirements in the POD controller design is to account for these ch…
▽ More
In recent years, transmission system operators have started requesting converter-interfaced generators (CIGs) to participate in grid services such as power oscillation damping (POD). As power systems are prone to topology changes because of connection and disconnection of generators and electrical lines, one of the most important requirements in the POD controller design is to account for these changes and to deal with them by using either adaptive or robust approaches. The robust approach is usually preferred by system operators because of the fixed structure of the controller. In this paper, a procedure to design POD controllers for CIG-based power plants that takes into consideration all possible network configurations is presented. This procedure is based on frequency-response techniques, so it is suitable for the commissioning in newly installed power plants, even in those cases when a detailed small-signal model of the system is not available. This procedure can be used to damp critical system modes by using active power, reactive power, or both power components simultaneously. The proposed procedure is applied to the design of the POD controller for a CIG-based power plant connected to the IEEE 39 Bus system. Simulations performed in Matlab and SimPowerSystems are used to validate the proposed design procedure.
△ Less
Submitted 13 April, 2023;
originally announced April 2023.
-
Centralised Multimode Power Oscillation Damping Controller for Photovoltaic Plants with Communication Delay Compensation
Authors:
Njegos Jankovic,
Javier Roldan-Perez,
Milan Prodanovic,
Luis Rouco
Abstract:
Low-frequency oscillations are an inherent phenomena in transmission networks and renewable energy plants should be configured to damp them. Commonly, a centralised controller is used in PV plants to coordinate PV generators via communication channels. However, the communication systems of PV plants introduce delays of a stochastic nature that degrade the performance of centralised control algorit…
▽ More
Low-frequency oscillations are an inherent phenomena in transmission networks and renewable energy plants should be configured to damp them. Commonly, a centralised controller is used in PV plants to coordinate PV generators via communication channels. However, the communication systems of PV plants introduce delays of a stochastic nature that degrade the performance of centralised control algorithms. Therefore, controllers for oscillation damping may not operate correctly unless the communication channel characteristics are not considered and compensated. In this paper, a centralised controller is proposed for the oscillation damping that uses a PV plant with all the realistic effects of communication channels taken into consideration. The communication channels are modelled based on measurements taken in a laboratory environment. The controller is designed to damp several modes of oscillation by using the open-loop phase shift compensation. Theoretical developments were validated in a laboratory using four converters acting as two PV inverters, a battery and a STATCOM. A real-time processing platform was used to implement the centralised controller and to deploy the communication infrastructure. Experimental results show the communication channels impose severe restrictions on the performance of centralised POD controllers, highlighting the importance of their accurate modelling and consideration during the controller design stage.
△ Less
Submitted 13 April, 2023;
originally announced April 2023.
-
Recursive Secondary Controller for Voltage Profile Improvement Based on Primary Virtual Admittance Control
Authors:
Dionysios Moutevelis,
Javier Roldan-Perez,
Njegos Jankovic,
Milan Prodanovic
Abstract:
This paper proposes a recursive, virtual admittance based, secondary controller for DG units that improves the voltage profile in distribution networks. First, the adaptation of the virtual admittance concept for the goal of voltage regulation is explained. Then, a recursive secondary controller is developed to periodically update the virtual admittance gains. The controller is formulated as an op…
▽ More
This paper proposes a recursive, virtual admittance based, secondary controller for DG units that improves the voltage profile in distribution networks. First, the adaptation of the virtual admittance concept for the goal of voltage regulation is explained. Then, a recursive secondary controller is developed to periodically update the virtual admittance gains. The controller is formulated as an optimization problem with current and stability limitations as constraints. Measurements across the grid, transmitted through low-bandwidth communications, are used to simplify the calculations, resulting in a recursive algorithm. Weight vectors are included in the objective function to allow participation flexibility of each converter. Results show that the primary virtual admittance controller is able to mitigate over- and under-voltages in steady state and under transient conditions. Subsequently, the secondary controller is shown to further improve the voltage profiles across the grid. Experimental results obtained from a laboratory environment, comprising three DG units and a grid emulator, validate the functionality of the complete control structure.
△ Less
Submitted 5 April, 2023; v1 submitted 26 October, 2022;
originally announced October 2022.
