-
Design and Analysis of Initial Access in Millimeter Wave Cellular Networks
Authors:
Yingzhe Li,
Jeffrey G. Andrews,
Francois Baccelli,
Thomas D. Novlan,
Charlie Zhang
Abstract:
Initial access is the process which allows a mobile user to first connect to a cellular network. It consists of two main steps: cell search (CS) on the downlink and random access (RA) on the uplink. Millimeter wave (mmWave) cellular systems typically must rely on directional beamforming (BF) in order to create a viable connection. The beamforming direction must therefore be learned-as well as used…
▽ More
Initial access is the process which allows a mobile user to first connect to a cellular network. It consists of two main steps: cell search (CS) on the downlink and random access (RA) on the uplink. Millimeter wave (mmWave) cellular systems typically must rely on directional beamforming (BF) in order to create a viable connection. The beamforming direction must therefore be learned-as well as used-in the initial access process for mmWave cellular networks. This paper considers four simple but representative initial access protocols that use various combinations of directional beamforming and omnidirectional transmission and reception at the mobile and the BS, during the CS and RA phases. We provide a system-level analysis of the success probability for CS and RA for each one, as well as of the initial access delay and user-perceived downlink throughput (UPT). For a baseline exhaustive search protocol, we find the optimal BS beamwidth and observe that in terms of initial access delay it is decreasing as blockage becomes more severe, but is relatively constant (about $π/12$) for UPT. Of the considered protocols, the best trade-off between initial access delay and UPT is achieved under a fast cell search protocol.
△ Less
Submitted 23 March, 2017; v1 submitted 18 September, 2016;
originally announced September 2016.
-
Modeling and Analyzing the Coexistence of Wi-Fi and LTE in Unlicensed Spectrum
Authors:
Yingzhe Li,
Francois Baccelli,
Jeffrey G. Andrews,
Thomas D. Novlan,
Jianzhong Charlie Zhang
Abstract:
We leverage stochastic geometry to characterize key performance metrics for neighboring Wi-Fi and LTE networks in unlicensed spectrum. Our analysis focuses on a single unlicensed frequency band, where the locations for the Wi-Fi access points (APs) and LTE eNodeBs (eNBs) are modeled as two independent homogeneous Poisson point processes. Three LTE coexistence mechanisms are investigated: (1) LTE w…
▽ More
We leverage stochastic geometry to characterize key performance metrics for neighboring Wi-Fi and LTE networks in unlicensed spectrum. Our analysis focuses on a single unlicensed frequency band, where the locations for the Wi-Fi access points (APs) and LTE eNodeBs (eNBs) are modeled as two independent homogeneous Poisson point processes. Three LTE coexistence mechanisms are investigated: (1) LTE with continuous transmission and no protocol modifications; (2) LTE with discontinuous transmission; and (3) LTE with listen-before-talk (LBT) and random back-off (BO). For each scenario, we have derived the medium access probability (MAP), the signal-to-interference-plus-noise ratio (SINR) coverage probability, the density of successful transmissions (DST), and the rate coverage probability for both Wi-Fi and LTE. Compared to the baseline scenario where one Wi-Fi network coexists with an additional Wi-Fi network, our results show that Wi-Fi performance is severely degraded when LTE transmits continuously. However, LTE is able to improve the DST and rate coverage probability of Wi-Fi while maintaining acceptable data rate performance when it adopts one or more of the following coexistence features: a shorter transmission duty cycle, lower channel access priority, or more sensitive clear channel assessment (CCA) thresholds.
△ Less
Submitted 19 February, 2016; v1 submitted 5 October, 2015;
originally announced October 2015.
-
Analytical Modeling of Uplink Cellular Networks
Authors:
Thomas D. Novlan,
Harpreet S. Dhillon,
Jeffrey G. Andrews
Abstract:
Cellular uplink analysis has typically been undertaken by either a simple approach that lumps all interference into a single deterministic or random parameter in a Wyner-type model, or via complex system level simulations that often do not provide insight into why various trends are observed. This paper proposes a novel middle way using point processes that is both accurate and also results in eas…
▽ More
Cellular uplink analysis has typically been undertaken by either a simple approach that lumps all interference into a single deterministic or random parameter in a Wyner-type model, or via complex system level simulations that often do not provide insight into why various trends are observed. This paper proposes a novel middle way using point processes that is both accurate and also results in easy-to-evaluate integral expressions based on the Laplace transform of the interference. We assume mobiles and base stations are randomly placed in the network with each mobile pairing up to its closest base station. Compared to related recent work on downlink analysis, the proposed uplink model differs in two key features. First, dependence is considered between user and base station point processes to make sure each base station serves a single mobile in the given resource block. Second, per-mobile power control is included, which further couples the transmission of mobiles due to location-dependent channel inversion. Nevertheless, we succeed in deriving the coverage (equivalently outage) probability of a typical link in the network. This model can be used to address a wide variety of system design questions in the future. In this paper we focus on the implications for power control and see that partial channel inversion should be used at low signal-to-interference-plus-noise ratio (SINR), while full power transmission is optimal at higher SINR.
△ Less
Submitted 21 March, 2013; v1 submitted 6 March, 2012;
originally announced March 2012.
-
Analytical Evaluation of Fractional Frequency Reuse for Heterogeneous Cellular Networks
Authors:
Thomas D. Novlan,
Radha Krishna Ganti,
Arunabha Ghosh,
Jeffrey G. Andrews
Abstract:
Interference management techniques are critical to the performance of heterogeneous cellular networks, which will have dense and overlapping coverage areas, and experience high levels of interference. Fractional frequency reuse (FFR) is an attractive interference management technique due to its low complexity and overhead, and significant coverage improvement for low-percentile (cell-edge) users.…
▽ More
Interference management techniques are critical to the performance of heterogeneous cellular networks, which will have dense and overlapping coverage areas, and experience high levels of interference. Fractional frequency reuse (FFR) is an attractive interference management technique due to its low complexity and overhead, and significant coverage improvement for low-percentile (cell-edge) users. Instead of relying on system simulations based on deterministic access point locations, this paper instead proposes an analytical model for evaluating Strict FFR and Soft Frequency Reuse (SFR) deployments based on the spatial Poisson point process. Our results both capture the non-uniformity of heterogeneous deployments and produce tractable expressions which can be used for system design with Strict FFR and SFR. We observe that the use of Strict FFR bands reserved for the users of each tier with the lowest average SINR provides the highest gains in terms of coverage and rate, while the use of SFR allows for more efficient use of shared spectrum between the tiers, while still mitigating much of the interference. Additionally, in the context of multi-tier networks with closed access in some tiers, the proposed framework shows the impact of cross-tier interference on closed access FFR, and informs the selection of key FFR parameters in open access.
△ Less
Submitted 3 December, 2011;
originally announced December 2011.
-
Analytical Evaluation of Fractional Frequency Reuse for OFDMA Cellular Networks
Authors:
Thomas David Novlan,
Radha Krishna Ganti,
Arunabha Ghosh,
Jeffrey G. Andrews
Abstract:
Fractional frequency reuse (FFR) is an interference management technique well-suited to OFDMA-based cellular networks wherein the cells are partitioned into spatial regions with different frequency reuse factors. To date, FFR techniques have been typically been evaluated through system-level simulations using a hexagonal grid for the base station locations. This paper instead focuses on analytical…
▽ More
Fractional frequency reuse (FFR) is an interference management technique well-suited to OFDMA-based cellular networks wherein the cells are partitioned into spatial regions with different frequency reuse factors. To date, FFR techniques have been typically been evaluated through system-level simulations using a hexagonal grid for the base station locations. This paper instead focuses on analytically evaluating the two main types of FFR deployments - Strict FFR and Soft Frequency Reuse (SFR) - using a Poisson point process to model the base station locations. The results are compared with the standard grid model and an actual urban deployment. Under reasonable special cases for modern cellular networks, our results reduce to simple closed-form expressions, which provide insight into system design guidelines and the relative merits of Strict FFR, SFR, universal reuse, and fixed frequency reuse. We observe that FFR provides an increase in the sum-rate as well as the well-known benefit of improved coverage for cell-edge users. Finally, a SINR-proportional resource allocation strategy is proposed based on the analytical expressions, showing that Strict FFR provides greater overall network throughput at low traffic loads, while SFR better balances the requirements of interference reduction and resource efficiency when the traffic load is high.
△ Less
Submitted 26 January, 2011;
originally announced January 2011.
