Formation of martensitic microstructure in epitaxial Ni-Mn-Ga films after fast cooling
Authors:
Yuru Ge,
Fabian Ganss,
Klara Lünser,
Satyakam Kar,
René Hübner,
Shengqiang Zhou,
Lars Rebohle,
Sebastian Fähler
Abstract:
Shape memory alloys have a wide range of applications, including high stroke actuation, energy-efficient ferroic cooling, and energy harvesting. These applications are based on a reversible martensitic transformation, which results in a complex microstructure in the martensitic state. Understanding the formation of this microstructure after fast heating and cooling is crucial, as a high cycle freq…
▽ More
Shape memory alloys have a wide range of applications, including high stroke actuation, energy-efficient ferroic cooling, and energy harvesting. These applications are based on a reversible martensitic transformation, which results in a complex microstructure in the martensitic state. Understanding the formation of this microstructure after fast heating and cooling is crucial, as a high cycle frequency is essential for achieving high power density in the mentioned applications. This article uses an epitaxial Ni-Mn-Ga film as a model system to study the formation of the martensitic microstructure, since the high surface-to-volume ratio of thin films enables rapid heating and cooling, and since the formation of a multi-level hierarchical microstructure during slow cooling of this material system is already well understood. We apply a millisecond flash lamp pulse of varying energy density on the Ni-Mn-Ga film and analyse the hierarchical martensitic microstructure afterwards. Substantial differences compared to slow cooling occur, which we attribute to the limited time available for the microstructure to form and to the thermal stress between film and substrate during rapid temperature changes.
△ Less
Submitted 30 September, 2024;
originally announced September 2024.
What is the speed limit of martensitic transformations?
Authors:
Stefan Schwabe,
Klara Lünser,
Daniel Schmidt,
Kornelius Nielsch,
Peter Gaal,
Sebastian Fähler
Abstract:
Structural martensitic transformations enable various applications, which range from high stroke actuation and sensing to energy efficient magnetocaloric refrigeration and thermomagnetic energy harvesting. All these emerging applications benefit from a fast transformation, but up to now the speed limit of martensitic transformations has not been explored. Here, we demonstrate that a martensite to…
▽ More
Structural martensitic transformations enable various applications, which range from high stroke actuation and sensing to energy efficient magnetocaloric refrigeration and thermomagnetic energy harvesting. All these emerging applications benefit from a fast transformation, but up to now the speed limit of martensitic transformations has not been explored. Here, we demonstrate that a martensite to austenite transformation can be completed in under ten nanoseconds. We heat an epitaxial Ni-Mn-Ga film with a laser pulse and use synchrotron diffraction to probe the influence of initial sample temperature and overheating on transformation rate and ratio. We demonstrate that an increase of thermal energy drives this transformation faster. Though the observed speed limit of 2.5 x 10^{27} (Js)^{-1} per unit cell leaves plenty of room for a further acceleration of applications, our analysis reveals that the practical limit will be the energy required for switching. Our experiments unveil that martensitic transformations obey similar speed limits as in microelectronics, which are expressed by the Margolus-Levitin theorem.
△ Less
Submitted 14 September, 2022; v1 submitted 25 February, 2022;
originally announced February 2022.
