Anisotropic interfacial tension, contact angles, and line tensions: A graphics-processing-unit-based Monte Carlo study of the Ising model
Authors:
Benjamin J. Block,
Suam Kim,
Peter Virnau,
Kurt Binder
Abstract:
As a generic example for crystals where the crystal-fluid interface tension depends on the orientation of the interface relative to the crystal lattice axes, the nearest neighbor Ising model on the simple cubic lattice is studied over a wide temperature range, both above and below the roughening transition temperature. Using a thin film geometry $L_x \times L_y \times L_z$ with periodic boundary c…
▽ More
As a generic example for crystals where the crystal-fluid interface tension depends on the orientation of the interface relative to the crystal lattice axes, the nearest neighbor Ising model on the simple cubic lattice is studied over a wide temperature range, both above and below the roughening transition temperature. Using a thin film geometry $L_x \times L_y \times L_z$ with periodic boundary conditions along the z-axis and two free $L_x \times L_y$ surfaces at which opposing surface fields $\pm H_{1}$ act, under conditions of partial wetting, a single planar interface inclined under a contact angle $θ< π/2$ relative to the yz-plane is stabilized. In the y-direction, a generalization of the antiperiodic boundary condition is used that maintains the translational invariance in y-direction despite the inhomogeneity of the magnetization distribution in this system. This geometry allows a simultaneous study of the angle-dependent interface tension, the contact angle, and the line tension (which depends on the contact angle, and on temperature). All these quantities are extracted from suitable thermodynamic integration procedures. In order to keep finite size effects as well as statistical errors small enough, rather large lattice sizes (of the order of 46 million sites) are found necessary, availability of very efficient code implementation of graphics processing units (GPUs) was crucial for the feasibility of this study.
△ Less
Submitted 20 November, 2014;
originally announced November 2014.
Curvature Dependence of Surface Free Energy of Liquid Drops and Bubbles: A Simulation Study
Authors:
B. J. Block,
S. K. Das,
M. Oettel,
P. Virnau,
K. Binder
Abstract:
We study the excess free energy due to phase coexistence of fluids by Monte Carlo simulations using successive umbrella sampling in finite LxLxL boxes with periodic boundary conditions. Both the vapor-liquid phase coexistence of a simple Lennard-Jones fluid and the coexistence between A-rich and B-rich phases of a symmetric binary (AB) Lennard-Jones mixture are studied, varying the density rho in…
▽ More
We study the excess free energy due to phase coexistence of fluids by Monte Carlo simulations using successive umbrella sampling in finite LxLxL boxes with periodic boundary conditions. Both the vapor-liquid phase coexistence of a simple Lennard-Jones fluid and the coexistence between A-rich and B-rich phases of a symmetric binary (AB) Lennard-Jones mixture are studied, varying the density rho in the simple fluid or the relative concentration x_A of A in the binary mixture, respectively. The character of phase coexistence changes from a spherical droplet (or bubble) of the minority phase (near the coexistence curve) to a cylindrical droplet (or bubble) and finally (in the center of the miscibility gap) to a slab-like configuration of two parallel flat interfaces. Extending the analysis of M. Schrader, P. Virnau, and K. Binder [Phys. Rev. E 79, 061104 (2009)], we extract the surface free energy gamma (R) of both spherical and cylindrical droplets and bubbles in the vapor-liquid case, and present evidence that for R -> Infinity the leading order (Tolman) correction for droplets has sign opposite to the case of bubbles, consistent with the Tolman length being independent on the sign of curvature. For the symmetric binary mixture the expected non-existence of the Tolman length is confirmed. In all cases {and for a range of radii} R relevant for nucleation theory, gamma(R) deviates strongly from gamma (Infinity) which can be accounted for by a term of order gamma(Infinity)/gamma(R)-1 ~ 1/R^2. Our results for the simple Lennard-Jones fluid are also compared to results from density functional theory and we find qualitative agreement in the behavior of gamma(R) as well as in the sign and magnitude of the Tolman length.
△ Less
Submitted 3 September, 2010;
originally announced September 2010.
