-
Direct Measurement of Interparticle Forces of Titan Aerosol Analogs ("Tholin") Using Atomic Force Microscopy
Authors:
Xinting Yu,
Sarah M. Hörst,
Chao He,
Patricia McGuiggan,
Nathan T. Bridges
Abstract:
To understand the origin of the dunes on Titan, it is important to investigate the material properties of Titan's organic sand particles on Titan. The organic sand may behave distinctively compared to the quartz/basaltic sand on terrestrial planets (Earth, Venus, Mars) due to differences in interparticle forces. We measured the surface energy (through contact angle measurements) and elastic modulu…
▽ More
To understand the origin of the dunes on Titan, it is important to investigate the material properties of Titan's organic sand particles on Titan. The organic sand may behave distinctively compared to the quartz/basaltic sand on terrestrial planets (Earth, Venus, Mars) due to differences in interparticle forces. We measured the surface energy (through contact angle measurements) and elastic modulus (through Atomic Force Microscopy, AFM) of the Titan aerosol analog (tholin). We find the surface energy of a tholin thin film is about 70.9 mN/m and its elastic modulus is about 3.0 GPa (similar to hard polymers like PMMA and polystyrene). For two 20 $μ$m diameter particles, the theoretical cohesion force is therefore 3.3 $μ$N. We directly measured interparticle forces for relevant materials: tholin particles are 0.8$\pm$0.6 $μ$N, while the interparticle cohesion between walnut shell particles (a typical model materials for the Titan Wind Tunnel, TWT) is only 0.4$\pm$0.1 $μ$N. The interparticle cohesion forces are much larger for tholins and presumably Titan sand particles than materials used in the TWT. This suggests we should increase the interparticle force in both analog experiments (TWT) and threshold models to correctly translate the results to real Titan conditions. The strong cohesion of tholins may also inform us how the small aerosol particles ($\sim$1 $μ$m) in Titan's atmosphere are transformed into large sand particles ($\sim$200 $μ$m). It may also support the cohesive sand formation mechanism suggested by Rubin and Hesp (2009), where only unidirectional wind is needed to form linear dunes on Titan.
△ Less
Submitted 18 October, 2017; v1 submitted 17 October, 2017;
originally announced October 2017.
-
The Effect of Adsorbed Liquid and Material Density on Saltation Threshold: Insight from Laboratory and Wind Tunnel Experiments
Authors:
Xinting Yu,
Sarah M. Hörst,
Chao He,
Nathan T. Bridges,
Devon M. Burr,
Joshua A. Sebree,
James K. Smith
Abstract:
Saltation threshold, the minimum wind speed for sediment transport, is a fundamental parameter in aeolian processes. The presence of liquid, such as water on Earth or methane on Titan, may affect the threshold values to a great extent. Sediment density is also crucial for determining threshold values. Here we provide quantitative data on density and water content of common wind tunnel materials th…
▽ More
Saltation threshold, the minimum wind speed for sediment transport, is a fundamental parameter in aeolian processes. The presence of liquid, such as water on Earth or methane on Titan, may affect the threshold values to a great extent. Sediment density is also crucial for determining threshold values. Here we provide quantitative data on density and water content of common wind tunnel materials that have been used to study conditions on Earth, Titan, Mars, and Venus. The measured density values for low density materials are higher compared to literature values, whereas for the high density materials, there is no such discrepancy. We also find that low density materials have much higher water content and longer atmospheric equilibration timescales compared to high density sediments. In the Titan Wind Tunnel, we performed threshold experiments with the standard walnut shells (125-150 μm, 7.2% water by mass) and dried walnut shells (1.7% water by mass). The threshold results for the two scenarios are almost the same, which indicates that humidity had a negligible effect on threshold for walnut shells in this experimental regime. When the water content is lower than 11.0%, the interparticle forces are dominated by adsorption forces, whereas at higher values the interparticle forces are dominated by much larger capillary forces. For materials with low equilibrium water content, like quartz sand, capillary forces dominate. When the interparticle forces are dominated by adsorption forces, the threshold does not increase with increasing relative humidity (RH). Only when the interparticle forces are dominated by capillary forces does the threshold start to increase with increasing RH/water content. Since tholins have a low methane content (0.3% at saturation, Curtis et al., 2008), we believe tholins would behave similarly to quartz sand when subjected to methane moisture. [abridged abstract]
△ Less
Submitted 29 June, 2017;
originally announced June 2017.
-
Hydrothermal formation of Clay-Carbonate alteration assemblages in the Nili Fossae region of Mars
Authors:
Adrian J. Brown,
Simon J. Hook,
Alice M. Baldridge,
James K. Crowley,
Nathan T. Bridges,
Bradley J. Thomson,
Giles M. Marion,
Carlos R. de Souza Filho,
Janice L. Bishop
Abstract:
The Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) has returned observations of the Nili Fossae region indicating the presence of Mg- carbonate in small (<10km sq2), relatively bright rock units that are commonly fractured (Ehlmann et al., 2008b). We have analyzed spectra from CRISM images and used co-located HiRISE images in order to further characterize these carbonate-bearing unit…
▽ More
The Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) has returned observations of the Nili Fossae region indicating the presence of Mg- carbonate in small (<10km sq2), relatively bright rock units that are commonly fractured (Ehlmann et al., 2008b). We have analyzed spectra from CRISM images and used co-located HiRISE images in order to further characterize these carbonate-bearing units. We applied absorption band mapping techniques to investigate a range of possible phyllosilicate and carbonate minerals that could be present in the Nili Fossae region. We also describe a clay-carbonate hydrothermal alteration mineral assemblage in the Archean Warrawoona Group of Western Australia that is a potential Earth analog to the Nili Fossae carbonate-bearing rock units. We discuss the geological and biological implications for hydrothermal processes on Noachian Mars.
△ Less
Submitted 5 February, 2014;
originally announced February 2014.
