-
Charge collection properties of TowerJazz 180 nm CMOS Pixel Sensors in dependence of pixel geometries and bias parameters, studied using a dedicated test-vehicle: the Investigator chip
Authors:
G. Aglieri Rinella,
G. Chaosong,
A. di Mauro,
J. Eum,
H. Hillemanns,
A. Junique,
M. Keil,
D. Kim,
H. Kim,
T. Kugathasan,
S. Lee,
M. Mager,
V. Manzari,
C. A. Marin Tobon,
P. Martinengo,
H. Mugnier,
L. Musa,
F. Reidt,
J. Rousset,
K. Sielewicz,
W. Snoeys,
M. Šuljić,
J. W. van Hoorne,
Q. M. Waheed,
P. Yang
, et al. (1 additional authors not shown)
Abstract:
This paper contains a compilation of parameters influencing the charge collection process extracted from a comprehensive study of partially depleted Monolithic Active Pixel Sensors with small (<25 um$^2$) collection electrodes fabricated in the TowerJazz 180 nm CMOS process. These results gave guidance for the optimisation of the diode implemented in ALPIDE, the chip used in the second generation…
▽ More
This paper contains a compilation of parameters influencing the charge collection process extracted from a comprehensive study of partially depleted Monolithic Active Pixel Sensors with small (<25 um$^2$) collection electrodes fabricated in the TowerJazz 180 nm CMOS process. These results gave guidance for the optimisation of the diode implemented in ALPIDE, the chip used in the second generation Inner Tracking System of ALICE, and serve as reference for future simulation studies of similar devices. The studied parameters include: reverse substrate bias, epitaxial layer thickness, charge collection electrode size and the spacing of the electrode to surrounding in-pixel electronics. The results from pixels of 28 um pitch confirm that even in partially depleted circuits, charge collection can be fast (<10 ns), and quantify the influence of the parameters onto the signal sharing and amplitudes, highlighting the importance of a correct spacing between wells and of the impact of the reverse substrate bias.
△ Less
Submitted 23 September, 2020; v1 submitted 22 September, 2020;
originally announced September 2020.
-
DMAPS Monopix developments in large and small electrode designs
Authors:
Christian Bespin,
Marlon Barbero,
Pierre Barrillon,
Ivan Berdalovic,
Siddharth Bhat,
Patrick Breugnon,
Ivan Caicedo,
Roberto Cardella,
Zongde Chen,
Yavuz Degerli,
Jochen Dingfelder,
Leyre Flores Sanz de Acedo,
Stephanie Godiot,
Fabrice Guilloux,
Toko Hirono,
Tomasz Hemperek,
Fabian Hügging,
Hans Krüger,
Thanushan Kugathasan,
Cesar Augusto Marin Tobon,
Konstantinos Moustakas,
Patrick Pangaud,
Heinz Pernegger,
Francesco Piro,
Petra Riedler
, et al. (8 additional authors not shown)
Abstract:
LF-Monopix1 and TJ-Monopix1 are depleted monolithic active pixel sensors (DMAPS) in 150 nm LFoundry and 180 nm TowerJazz CMOS technologies respectively. They are designed for usage in high-rate and high-radiation environments such as the ATLAS Inner Tracker at the High-Luminosity Large Hadron Collider (HL-LHC). Both chips are read out using a column-drain readout architecture. LF-Monopix1 follows…
▽ More
LF-Monopix1 and TJ-Monopix1 are depleted monolithic active pixel sensors (DMAPS) in 150 nm LFoundry and 180 nm TowerJazz CMOS technologies respectively. They are designed for usage in high-rate and high-radiation environments such as the ATLAS Inner Tracker at the High-Luminosity Large Hadron Collider (HL-LHC). Both chips are read out using a column-drain readout architecture. LF-Monopix1 follows a design with large charge collection electrode where readout electronics are placed inside. Generally, this offers a homogeneous electrical field in the sensor and short drift distances. TJ-Monopix1 employs a small charge collection electrode with readout electronics separated from the electrode and an additional n-type implant to achieve full depletion of the sensitive volume. This approach offers a low sensor capacitance and therefore low noise and is typically implemented with small pixel size. Both detectors have been characterized before and after irradiation using lab tests and particle beams.
△ Less
Submitted 9 July, 2020; v1 submitted 3 June, 2020;
originally announced June 2020.
-
CMOS Monolithic Pixel Sensors based on the Column-Drain Architecture for the HL-LHC Upgrade
Authors:
K. Moustakas,
M. Barbero,
I. Berdalovic,
C. Bespin,
P. Breugnon,
I. Caicedo,
R. Cardella,
Y. Degerli,
N. Egidos Plaja,
S. Godiot,
F. Guilloux,
T. Hemperek,
T. Hirono,
H. Krueger,
T. Kugathasan,
C. A. Marin Tobon,
P. Pangaud,
H. Pernegger,
E. J. Schioppa,
W. Snoeys,
M. Vandenbroucke,
T. Wang,
N. Wermes
Abstract:
Depleted Monolithic Active Pixel Sensors (DMAPS) constitute a promising low cost alternative for the outer layers of the ATLAS experiment Inner Tracker (ITk). Realizations in modern, high resistivity CMOS technologies enhance their radiation tolerance by achieving substantial depletion of the sensing volume. Two DMAPS prototypes that use the same "column-drain" readout architecture and are based o…
▽ More
Depleted Monolithic Active Pixel Sensors (DMAPS) constitute a promising low cost alternative for the outer layers of the ATLAS experiment Inner Tracker (ITk). Realizations in modern, high resistivity CMOS technologies enhance their radiation tolerance by achieving substantial depletion of the sensing volume. Two DMAPS prototypes that use the same "column-drain" readout architecture and are based on different sensor implementation concepts named LF-Monopix and TJ-Monopix have been developed for the High Luminosity upgrade of the Large Hardon Collider (HL-LHC).
LF-Monopix was fabricated in the LFoundry 150 nm technology and features pixel size of $50x250~μm^{2}$ and large collection electrode opted for high radiation tolerance. Detection efficiency up to 99\% has been measured after irradiation to $1\cdot10^{15}~n_{eq}/cm^{2}$. TJ-Monopix is a large scale $(1x2~cm^{2})$ prototype featuring pixels of $36x40~μm^{2}$ size. It was fabricated in a novel TowerJazz 180 nm modified process that enables full depletion of the sensitive layer, while employing a small collection electrode that is less sensitive to crosstalk. The resulting small sensor capacitance ($<=3~fF$) is exploited by a compact, low power front end optimized to meet the 25ns timing requirement. Measurement results demonstrate the sensor performance in terms of Equivalent Noise Charge (ENC) $\approx11e^{-}$, threshold $\approx300~e^-$, threshold dispersion $\approx30~e^-$ and total power consumption lower than $120~mW/cm^2$.
△ Less
Submitted 10 September, 2018;
originally announced September 2018.
-
Depleted fully monolithic CMOS pixel detectors using a column based readout architecture for the ATLAS Inner Tracker upgrade
Authors:
T. Wang,
M. Barbero,
I. Berdalovic,
C. Bespin,
S. Bhat,
P. Breugnon,
I. Caicedo,
R. Cardella,
Z. Chen,
Y. Degerli,
N. Egidos,
S. Godiot,
F. Guilloux,
T. Hemperek,
T. Hirono,
H. Krüger,
T. Kugathasan,
F. Hügging,
C. A. Marin Tobon,
K. Moustakas,
P. Pangaud,
P. Schwemling,
H. Pernegger,
D-L. Pohl,
A. Rozanov
, et al. (3 additional authors not shown)
Abstract:
Depleted monolithic active pixel sensors (DMAPS), which exploit high voltage and/or high resistivity add-ons of modern CMOS technologies to achieve substantial depletion in the sensing volume, have proven to have high radiation tolerance towards the requirements of ATLAS in the high-luminosity LHC era. Depleted fully monolithic CMOS pixels with fast readout architectures are currently being develo…
▽ More
Depleted monolithic active pixel sensors (DMAPS), which exploit high voltage and/or high resistivity add-ons of modern CMOS technologies to achieve substantial depletion in the sensing volume, have proven to have high radiation tolerance towards the requirements of ATLAS in the high-luminosity LHC era. Depleted fully monolithic CMOS pixels with fast readout architectures are currently being developed as promising candidates for the outer pixel layers of the future ATLAS Inner Tracker, which will be installed during the phase II upgrade of ATLAS around year 2025. In this work, two DMAPS prototype designs, named LF-MonoPix and TJ-MonoPix, are presented. LF-MonoPix was designed and fabricated in the LFoundry 150~nm CMOS technology, and TJ-MonoPix has been designed in the TowerJazz 180~nm CMOS technology. Both chips employ the same readout architecture, i.e. the column drain architecture, whereas different sensor implementation concepts are pursued. The design of the two prototypes will be described. First measurement results for LF-MonoPix will also be shown.
△ Less
Submitted 29 September, 2017;
originally announced October 2017.
-
Inclusive J/psi production in pp collisions at sqrt(s) = 2.76 TeV
Authors:
ALICE Collaboration,
B. Abelev,
J. Adam,
D. Adamova,
A. M. Adare,
M. M. Aggarwal,
G. Aglieri Rinella,
A. G. Agocs,
A. Agostinelli,
S. Aguilar Salazar,
Z. Ahammed,
A. Ahmad Masoodi,
N. Ahmad,
S. U. Ahn,
A. Akindinov,
D. Aleksandrov,
B. Alessandro,
R. Alfaro Molina,
A. Alici,
A. Alkin,
E. Almaraz Avina,
J. Alme,
T. Alt,
V. Altini,
S. Altinpinar
, et al. (948 additional authors not shown)
Abstract:
The ALICE Collaboration has measured inclusive J/psi production in pp collisions at a center of mass energy sqrt(s)=2.76 TeV at the LHC. The results presented in this Letter refer to the rapidity ranges |y|<0.9 and 2.5<y<4 and have been obtained by measuring the electron and muon pair decay channels, respectively. The integrated luminosities for the two channels are L^e_int=1.1 nb^-1 and L^mu_int=…
▽ More
The ALICE Collaboration has measured inclusive J/psi production in pp collisions at a center of mass energy sqrt(s)=2.76 TeV at the LHC. The results presented in this Letter refer to the rapidity ranges |y|<0.9 and 2.5<y<4 and have been obtained by measuring the electron and muon pair decay channels, respectively. The integrated luminosities for the two channels are L^e_int=1.1 nb^-1 and L^mu_int=19.9 nb^-1, and the corresponding signal statistics are N_J/psi^e+e-=59 +/- 14 and N_J/psi^mu+mu-=1364 +/- 53. We present dsigma_J/psi/dy for the two rapidity regions under study and, for the forward-y range, d^2sigma_J/psi/dydp_t in the transverse momentum domain 0<p_t<8 GeV/c. The results are compared with previously published results at sqrt(s)=7 TeV and with theoretical calculations.
△ Less
Submitted 6 November, 2012; v1 submitted 16 March, 2012;
originally announced March 2012.
