-
Technology and Performance Benchmarks of IQM's 20-Qubit Quantum Computer
Authors:
Leonid Abdurakhimov,
Janos Adam,
Hasnain Ahmad,
Olli Ahonen,
Manuel Algaba,
Guillermo Alonso,
Ville Bergholm,
Rohit Beriwal,
Matthias Beuerle,
Clinton Bockstiegel,
Alessio Calzona,
Chun Fai Chan,
Daniele Cucurachi,
Saga Dahl,
Rakhim Davletkaliyev,
Olexiy Fedorets,
Alejandro Gomez Frieiro,
Zheming Gao,
Johan Guldmyr,
Andrew Guthrie,
Juha Hassel,
Hermanni Heimonen,
Johannes Heinsoo,
Tuukka Hiltunen,
Keiran Holland
, et al. (89 additional authors not shown)
Abstract:
Quantum computing has tremendous potential to overcome some of the fundamental limitations present in classical information processing. Yet, today's technological limitations in the quality and scaling prevent exploiting its full potential. Quantum computing based on superconducting quantum processing units (QPUs) is among the most promising approaches towards practical quantum advantage.
In thi…
▽ More
Quantum computing has tremendous potential to overcome some of the fundamental limitations present in classical information processing. Yet, today's technological limitations in the quality and scaling prevent exploiting its full potential. Quantum computing based on superconducting quantum processing units (QPUs) is among the most promising approaches towards practical quantum advantage.
In this article the basic technological approach of IQM Quantum Computers is described covering both the QPU and the rest of the full-stack quantum computer. In particular, the focus is on a 20-qubit quantum computer featuring the Garnet QPU and its architecture, which we will scale up to 150 qubits. We also present QPU and system-level benchmarks, including a median 2-qubit gate fidelity of 99.5% and genuinely entangling all 20 qubits in a Greenberger-Horne-Zeilinger (GHZ) state.
△ Less
Submitted 22 August, 2024;
originally announced August 2024.
-
On-chip magnetic cooling of a nanoelectronic device
Authors:
D. I. Bradley,
A. M. Guénault,
D. Gunnarsson,
R. P. Haley,
S. Holt,
A. T. Jones,
Yu. A. Pashkin,
J. Penttilä,
J. R. Prance,
M. Prunnila,
L. Roschier
Abstract:
We demonstrate significant cooling of electrons in a nanostructure below 10 mK by demagnetisation of thin-film copper on a silicon chip. Our approach overcomes the typical bottleneck of weak electron-phonon scattering by coupling the electrons directly to a bath of refrigerated nuclei, rather than cooling via phonons in the host lattice. Consequently, weak electron-phonon scattering becomes an adv…
▽ More
We demonstrate significant cooling of electrons in a nanostructure below 10 mK by demagnetisation of thin-film copper on a silicon chip. Our approach overcomes the typical bottleneck of weak electron-phonon scattering by coupling the electrons directly to a bath of refrigerated nuclei, rather than cooling via phonons in the host lattice. Consequently, weak electron-phonon scattering becomes an advantage. It allows the electrons to be cooled for an experimentally useful period of time to temperatures colder than the dilution refrigerator platform, the incoming electrical connections, and the host lattice. There are efforts worldwide to reach sub-millikelvin electron temperatures in nanostructures to study coherent electronic phenomena and improve the operation of nanoelectronic devices. On-chip magnetic cooling is a promising approach to meet this challenge. The method can be used to reach low, local electron temperatures in other nanostructures, obviating the need to adapt traditional, large demagnetisation stages. We demonstrate the technique by applying it to a nanoelectronic primary thermometer that measures its internal electron temperature. Using an optimised demagnetisation process, we demonstrate cooling of the on-chip electrons from 9 mK to below 5 mK for over 1000 seconds.
△ Less
Submitted 4 July, 2017; v1 submitted 8 November, 2016;
originally announced November 2016.
-
Traceable Coulomb Blockade Thermometry
Authors:
Ossi Hahtela,
Emma Mykkanen,
Antti Kemppinen,
Matthias Meschke,
Mika Prunnila,
David Gunnarsson,
Leif Roschier,
Jari Penttila,
Jukka Pekola
Abstract:
We present a measurement and analysis scheme for determining traceable thermodynamic temperature at cryogenic temperatures using Coulomb blockade thermometry. The uncertainty of the electrical measurement is improved by utilizing two sampling digital voltmeters instead of the traditional lock-in technique. The remaining uncertainty is dominated by that of the numerical analysis of the measurement…
▽ More
We present a measurement and analysis scheme for determining traceable thermodynamic temperature at cryogenic temperatures using Coulomb blockade thermometry. The uncertainty of the electrical measurement is improved by utilizing two sampling digital voltmeters instead of the traditional lock-in technique. The remaining uncertainty is dominated by that of the numerical analysis of the measurement data. Two analysis methods are demonstrated: numerical fitting of the full conductance curve and measuring the height of the conductance dip. The complete uncertainty analysis shows that using either analysis method the relative combined standard uncertainty (k = 1) in determining the thermodynamic temperature in the temperature range from 20 mK to 200 mK is below 0.5 %. In this temperature range, both analysis methods produced temperature estimates that deviated from 0.39 % to 0.67 % from the reference temperatures provided by a superconducting reference point device calibrated against the Provisional Low Temperature Scale of 2000.
△ Less
Submitted 21 December, 2016; v1 submitted 22 September, 2016;
originally announced September 2016.
-
Nanoelectronic thermometers optimised for sub-10 millikelvin operation
Authors:
J. R. Prance,
D. I. Bradley,
R. E. George,
R. P. Haley,
Yu. A. Pashkin,
M. Sarsby,
J. Penttilä,
L. Roschier,
D. Gunnarsson,
H. Heikkinen,
M. Prunnila
Abstract:
We report the cooling of electrons in nanoelectronic Coulomb blockade thermometers below 4 mK. Above 7 mK the devices are in good thermal contact with the environment, well isolated from electrical noise, and not susceptible to self-heating. This is attributed to an optimised design that incorporates cooling fins with a high electron-phonon coupling and on-chip electronic filters, combined with a…
▽ More
We report the cooling of electrons in nanoelectronic Coulomb blockade thermometers below 4 mK. Above 7 mK the devices are in good thermal contact with the environment, well isolated from electrical noise, and not susceptible to self-heating. This is attributed to an optimised design that incorporates cooling fins with a high electron-phonon coupling and on-chip electronic filters, combined with a low-noise electronic measurement setup. Below 7 mK the electron temperature is seen to diverge from the ambient temperature. By immersing a Coulomb Blockade Thermometer in the 3He/4He refrigerant of a dilution refrigerator, we measure a lowest electron temperature of 3.7 mK.
△ Less
Submitted 10 June, 2015; v1 submitted 27 May, 2015;
originally announced May 2015.
-
Primary thermometry in the intermediate Coulomb blockade regime
Authors:
A. V. Feshchenko,
M. Meschke,
D. Gunnarsson,
M. Prunnila,
L. Roschier,
J. S. Penttilä,
J. P. Pekola
Abstract:
We investigate Coulomb blockade thermometers (CBT) in an intermediate temperature regime, where measurements with enhanced accuracy are possible due to the increased magnitude of the differential conductance dip. Previous theoretical results show that corrections to the half width and to the depth of the measured conductance dip of a sensor are needed, when leaving the regime of weak Coulomb block…
▽ More
We investigate Coulomb blockade thermometers (CBT) in an intermediate temperature regime, where measurements with enhanced accuracy are possible due to the increased magnitude of the differential conductance dip. Previous theoretical results show that corrections to the half width and to the depth of the measured conductance dip of a sensor are needed, when leaving the regime of weak Coulomb blockade towards lower temperatures. In the present work, we demonstrate experimentally that the temperature range of a CBT sensor can be extended by employing these corrections without compromising the primary nature or the accuracy of the thermometer.
△ Less
Submitted 8 April, 2013; v1 submitted 4 June, 2012;
originally announced June 2012.
-
Measuring the quantum states of a mesoscopic SQUID using a small Josephson junction
Authors:
René Lindell,
Jari Penttilä,
Mika Sillanpää,
Pertti Hakonen
Abstract:
We have experimentally studied the energy levels of a mesoscopic SQUID using inelastic Cooper-pair tunneling. The tunneling in a small Josephson junction depends strongly on its electromagnetic environment. We use this fact to do energy level spectroscopy of a SQUID-loop by coupling it to a small junction. Our samples with strong quasiparticle dissipation are well described by a model of a parti…
▽ More
We have experimentally studied the energy levels of a mesoscopic SQUID using inelastic Cooper-pair tunneling. The tunneling in a small Josephson junction depends strongly on its electromagnetic environment. We use this fact to do energy level spectroscopy of a SQUID-loop by coupling it to a small junction. Our samples with strong quasiparticle dissipation are well described by a model of a particle localized in one of the dips in a cosine-potential, while in the samples with weak dissipation we can see formation of energy bands.
△ Less
Submitted 25 March, 2003;
originally announced March 2003.
-
Multiwalled carbon nanotube: Luttinger liquid or not?
Authors:
R. Tarkiainen,
M. Ahlskog,
J. Penttilä,
L. Roschier,
P. Hakonen,
M. Paalanen,
E. Sonin
Abstract:
We have measured IV-curves of multiwalled carbon nanotubes using end contacts. At low voltages, the tunneling conductance obeys non-Ohmic power law, which is predicted both by the Luttinger liquid and the environment-quantum-fluctuation theories. However, at higher voltages we observe a crossover to Ohm's law with a Coulomb-blockade offset, which agrees with the environment-quantum-fluctuation t…
▽ More
We have measured IV-curves of multiwalled carbon nanotubes using end contacts. At low voltages, the tunneling conductance obeys non-Ohmic power law, which is predicted both by the Luttinger liquid and the environment-quantum-fluctuation theories. However, at higher voltages we observe a crossover to Ohm's law with a Coulomb-blockade offset, which agrees with the environment-quantum-fluctuation theory, but cannot be explained by the Luttinger-liquid theory. From the high-voltage tunneling conductance we determine the transmission line parameters of the nanotubes.
△ Less
Submitted 2 April, 2001;
originally announced April 2001.
-
Effect of quantum noise on Coulomb blockade in normal tunnel junctions at high voltages
Authors:
J. S. Penttila,
U. Parts,
P. J. Hakonen,
M. A. Paalanen,
E. B. Sonin
Abstract:
We have investigated asymptotic behavior of normal tunnel junctions at voltages where even the best ohmic environments start to look like RC transmission lines. In the experiments, this is manifested by an exceedingly slow approach to the linear behavior above the Coulomb gap. As expected on the basis of the quantum theory taking into account interaction with the environmental modes, better fits…
▽ More
We have investigated asymptotic behavior of normal tunnel junctions at voltages where even the best ohmic environments start to look like RC transmission lines. In the experiments, this is manifested by an exceedingly slow approach to the linear behavior above the Coulomb gap. As expected on the basis of the quantum theory taking into account interaction with the environmental modes, better fits are obtained using 1/sqrt{V}- than 1/V- dependence for the asymptote. These results agree with the horizon picture if the frequency-dependent phase velocity is employed instead of the speed of light in order to determine the extent of the surroundings seen by the junction.
△ Less
Submitted 20 October, 1999;
originally announced October 1999.
-
"Superconductor-Insulator transition" in a single Josephson junction
Authors:
J. S. Penttila,
U. Parts,
P. J. Hakonen,
M. A. Paalanen,
E. B. Sonin
Abstract:
VI-curves of resistively shunted single Josephson junctions with different capacitances and tunneling resistances are found to display a crossover between two types of VI-curves: one without and another with a resistance bump (negative second derivative) at zero-bias. The crossover corresponds to the dissipative phase transition (superconductor-insulator transition) at which macroscopic quantum…
▽ More
VI-curves of resistively shunted single Josephson junctions with different capacitances and tunneling resistances are found to display a crossover between two types of VI-curves: one without and another with a resistance bump (negative second derivative) at zero-bias. The crossover corresponds to the dissipative phase transition (superconductor-insulator transition) at which macroscopic quantum tunneling delocalizes the Josephson phase and destroys superconductivity. Our measured phase diagram does not agree with the diagram predicted by the original theory, but does coincide with a theory that takes into account the accuracy of voltage measurements and thermal fluctuations.
△ Less
Submitted 14 December, 1998; v1 submitted 23 September, 1998;
originally announced September 1998.
